MY350Z.COM - Nissan 350Z and 370Z Forum Discussion - Search Results

Notices
Search: Posts Made By: Chihuahuamaster
Showing results 1 to 24 of 24
Search took 0.01 seconds.
07-03-2019, 04:53 PM
Replies: 10
Views: 368
Posted By Chihuahuamaster

I actually have those exact sizes in Michelin...

I actually have those exact sizes in Michelin PSS's (runs slightly larger than some other tires), and they fit almost perfect with +12 offset wheels, and lowered. So you shouldn't have any trouble...
06-24-2019, 05:17 PM
Replies: 11
Views: 1,607
Posted By Chihuahuamaster

If you do replace the bolt, the torque spec has...

If you do replace the bolt, the torque spec has already been stated, but I would just go by feel, then you can tell if it's about to snap. I had a similar occurrence with the valve cover bolts.
...
06-19-2019, 09:19 AM
Replies: 8
Views: 1,175
Posted By Chihuahuamaster

It sounds alot like the fuel pump itself is going...

It sounds alot like the fuel pump itself is going out. One of the main indications is hard to start when hot, but after sitting for a while it fires up.

As for all of the engine codes, dying while...
05-26-2019, 05:23 PM
Replies: 16
Views: 842
Posted By Chihuahuamaster

Well in case you end up replacing the radiator,...

Well in case you end up replacing the radiator, here is a link to where I found the part:
Rockauto-radiator...
05-06-2019, 06:11 PM
Replies: 61
Views: 3,685
Posted By Chihuahuamaster

You could try adjustment from the hood latch as...

You could try adjustment from the hood latch as well, can be moved vertically. The rubber bump stops would be used for slight adjustments and to help with vibrations.

However, it seems that...
05-05-2019, 07:26 AM
Replies: 3
Views: 529
Posted By Chihuahuamaster

Try pushing the door further open, or parking on...

Try pushing the door further open, or parking on a slight decline facing the direction appropriate to your door functioning needs.
04-29-2019, 04:14 PM
Replies: 11
Views: 2,840
Posted By Chihuahuamaster

I don't know if you plan on taking the lower...

I don't know if you plan on taking the lower manifold off, but if so, you will need a new metal gasket for both sides.

The reason you may want to do this is because you will likely find that the...
04-12-2019, 05:53 PM
Replies: 5
Views: 426
Posted By Chihuahuamaster

They might work fine, but you're taking a risk on...

They might work fine, but you're taking a risk on arguably one of the most important areas of your vehicle for safety, i.e. keeping the wheels connected to the car. When i purchased my car it had...
03-24-2019, 06:28 AM
Replies: 10
Views: 1,149
Posted By Chihuahuamaster

Popping noise, automatic z, = fail... However I...

Popping noise, automatic z, = fail... However I would recommend any local exhaust shop, and ask them to 'straight pipe' your car. Seems more up your alley.
03-23-2019, 03:40 PM
Replies: 5
Views: 543
Posted By Chihuahuamaster

Funny this would come up. I recently got a $130...

Funny this would come up. I recently got a $130 fine for around 8% window tint, in TX.

I should have rolled the windows all the way down, but had left them partially up when I was pulled over....
03-09-2019, 03:05 PM
Replies: 11
Views: 1,803
Posted By Chihuahuamaster

A single exit exhaust will generally make more...

A single exit exhaust will generally make more power than a dual on these cars. This is also dependent on the other sections of your exhaust. The single exhaust will also be louder than a dual.
02-17-2019, 06:09 PM
Replies: 2
Views: 1,482
Posted By Chihuahuamaster

I had a paint peeling issue on an old mustang. I...

I had a paint peeling issue on an old mustang. I think you'll find that even if you successfully touch up the peeled off section, the surrounding area will begin to peel over time, but it doesn't...
01-31-2019, 04:45 PM
Replies: 5
Views: 682
Posted By Chihuahuamaster

It sounds like you know your way around modifying...

It sounds like you know your way around modifying a car, so you can go one of two ways in my opinion. Find the cheapest car you can, which leaves you more 'mod' money to do what you want with it....
01-24-2019, 05:49 AM
Replies: 8
Views: 1,703
Posted By Chihuahuamaster

Without seeing the wiring It will be hard to...

Without seeing the wiring It will be hard to pinpoint the issue. I'm assuming you're talking about the 06+ HID headlights.

Check to make sure you have the correct bulbs, and that the wiring wasn't...
01-23-2019, 04:46 PM
Replies: 5
Views: 708
Posted By Chihuahuamaster

I've also heard good things about the ISR y-pipe....

I've also heard good things about the ISR y-pipe. I'm sure it's more reasonably priced as well.

I would advise against the Motordyne XYZ unless you absolutely need the mid resonator/ catalytic...
01-12-2019, 08:39 PM
Replies: 2
Views: 1,277
Posted By Chihuahuamaster

Looking at the retrofit kit on Z1, I believe they...

Looking at the retrofit kit on Z1, I believe they are different and not interchangeable.
https://www.z1motorsports.com/advanced_search_result.php?keywords=Cruise+retrofit

The only name I can...
Forum: Tuning
12-21-2018, 01:54 PM
Replies: 18
Views: 1,376
Posted By Chihuahuamaster

Every engine and dyno reading is different, but...

Every engine and dyno reading is different, but you could probably expect around 260-270 whp at the higher end.
Forum: Tuning
12-17-2018, 12:24 PM
Replies: 18
Views: 1,376
Posted By Chihuahuamaster

With only a cat-back exhaust I would hold off on...

With only a cat-back exhaust I would hold off on the tune, until you put the headers on. Even then, with exhaust only, you may not benefit much power-wise, but you will want to watch your A/F ratio,...
12-13-2018, 11:20 AM
Replies: 14
Views: 2,774
Posted By Chihuahuamaster

Well I would definitely take care of maintenance...

Well I would definitely take care of maintenance or any known problems before modifying anything else.
It's normal to hear some flywheel chatter at low rpms, but you will have to see if there's a...
12-13-2018, 10:22 AM
Replies: 14
Views: 2,774
Posted By Chihuahuamaster

Welcome, the type of modifications will depend on...

Welcome, the type of modifications will depend on what you want to do with the car. You say you have an intake and exhaust, you have to consider if it's worth it to bother with any extra power mods...
11-25-2018, 09:14 PM
Replies: 1
Views: 544
Posted By Chihuahuamaster

If you already have high flow cats, just get the...

If you already have high flow cats, just get the XYZ with the resonator attachment, this will likely be the best option to cut down rasp, with performance still in mind.

Just to add, I have the...
11-25-2018, 01:43 PM
Replies: 2
Views: 452
Posted By Chihuahuamaster

Your issue sounds more like a bad sending unit/...

Your issue sounds more like a bad sending unit/ sensor for the gauge, because of the sporadic pressures.

When turning the steering wheel, this puts strain on the power steering system, and the rpm...
11-11-2018, 03:08 PM
Replies: 7
Views: 1,104
Posted By Chihuahuamaster

This seems like the best place to put a discount...

This seems like the best place to put a discount code for RockAuto. Not an advertisement or anything, but I've ordered alot of parts from there and you can often find OEM parts (denso for...
10-19-2018, 01:15 PM
Replies: 1
Views: 621
Posted By Chihuahuamaster

Well seems I solved the problem. If anyone has an...

Well seems I solved the problem. If anyone has an issue with this you can bolt everything but the tie rod onto the knuckle. Leave the tie rod off until you get the compression rod attached. This...
Showing results 1 to 24 of 24


 
Forum Jump

Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.