MY350Z.COM - Nissan 350Z and 370Z Forum Discussion - Search Results

Notices
 
Search: Posts Made By: Atreyu'z 350
Showing results 1 to 30 of 179
Search took 0.03 seconds.
05-21-2018, 08:50 AM
Replies: 4
Views: 482
Posted By Atreyu'z 350

OK.. From what you described, it sounds like you...

OK.. From what you described, it sounds like you need a new clutch and tob. I would drop the trans and inspect those components. With your symptoms, dropping the trans and inspecting those components...
05-14-2018, 09:14 AM
Replies: 7
Views: 847
Posted By Atreyu'z 350

lol.. Just leave it off. It would've held you...

lol.. Just leave it off. It would've held you back if it had stayed on.
Forum: Videos
05-10-2018, 04:58 AM
Replies: 2
Views: 362
Posted By Atreyu'z 350

I've always liked the S2000.

I've always liked the S2000.
05-04-2018, 02:15 PM
Replies: 19
Views: 1,095
Posted By Atreyu'z 350

I think you should perform a leak-down test on...

I think you should perform a leak-down test on that engine before you start throwing parts at it.
05-02-2018, 11:12 AM
Replies: 130
Views: 22,714
Posted By Atreyu'z 350

Yes sir.. I live 64 miles away from my job. It's...

Yes sir.. I live 64 miles away from my job. It's not a bad drive, just long. Only have four lights along the way. All back roads and highway.. My fiancé and I are moving closer this August. Can't...
04-29-2018, 05:34 AM
Replies: 1
Views: 770
Posted By Atreyu'z 350

It'll bolt up just fine, but you will loose the...

It'll bolt up just fine, but you will loose the SynchroRevMatch system that comes with the 370Z tranny. Also, you will have to manually wire in your reverse lights(easy), starter interlock...
04-25-2018, 04:08 PM
Replies: 37
Views: 1,728
Posted By Atreyu'z 350

I think if you would've explained your reasoning...

I think if you would've explained your reasoning behind this opinion in your first post as you did right here things would've gone a little differently.. I can understand your feelings, and I would...
04-25-2018, 03:10 PM
Replies: 37
Views: 1,753
Posted By Atreyu'z 350

Zak, my name's Matt. You can call me that. I've...

Zak, my name's Matt. You can call me that. I've established you're good people. :icon44:
04-24-2018, 04:19 PM
Replies: 37
Views: 1,753
Posted By Atreyu'z 350

Posts #4 and #5. I'm assuming his vague...

Posts #4 and #5.

I'm assuming his vague 'yes' in post 5 was him answering my two part question about the location of the noise. And sure, a heat shield is definitely another possibility, not...
04-18-2018, 05:42 AM
Replies: 73
Views: 6,599
Posted By Atreyu'z 350

Yeah well that dickhead from Kazakstan deserved a...

Yeah well that dickhead from Kazakstan deserved a little 'tude.. And nice job so far, Kevin. :thumbup:
Forum: New Owners
04-13-2018, 07:55 PM
Replies: 10
Views: 687
Posted By Atreyu'z 350

Nice. :thumbup:

Nice. :thumbup:
04-09-2018, 06:55 AM
Replies: 22
Views: 1,179
Posted By Atreyu'z 350

+1 to everything up there.. OP, I have...

+1 to everything up there..


OP, I have an '05 Z with the DE engine. Bought it a little over two years ago with 70k on the clock. It was a one owner car with all of the maintenance records from...
04-07-2018, 03:30 PM
Replies: 15,358
Views: 1,225,508
Posted By Atreyu'z 350

I installed the clutch pedal, clutch master...

I installed the clutch pedal, clutch master cylinder/reservoir, and the MT brake pedal for my 5AT to 6MT swap.. Just had to remove some felt insulation, take some measurements and drill some holes.....
04-03-2018, 03:57 PM
Replies: 10
Views: 488
Posted By Atreyu'z 350

Dude.. You need to go take your medicine now.

Dude.. You need to go take your medicine now.
04-02-2018, 11:06 AM
Replies: 10
Views: 720
Posted By Atreyu'z 350

If you're not in a position to where you can...

If you're not in a position to where you can request a flatbed, then the drive wheels need to be off the ground.
03-31-2018, 08:45 AM
Replies: 13
Views: 3,201
Posted By Atreyu'z 350

Are you able to get consistent heat from the...

Are you able to get consistent heat from the vents when you turn the heater on high heat? And there's no leaks anywhere?
03-25-2018, 10:46 AM
Replies: 13
Views: 763
Posted By Atreyu'z 350

So THAT'S what that's for.. Never knew that

So THAT'S what that's for.. Never knew that
03-24-2018, 07:26 PM
Replies: 13
Views: 763
Posted By Atreyu'z 350

Interesting. I thought that stud was there as a...

Interesting. I thought that stud was there as a kind of 'designator' for the front wheels only, so as to not confuse the front wheels with the rear wheels because of the staggered set-up......?
Forum: New Owners
03-22-2018, 12:18 PM
Replies: 2
Views: 370
Posted By Atreyu'z 350

Whazuup.

Whazuup.
03-22-2018, 11:28 AM
Replies: 15,358
Views: 1,225,508
Posted By Atreyu'z 350

I gotta do all my bushings too... Now I'm just...

I gotta do all my bushings too... Now I'm just getting some parts for a homemade catch can.. Awesome.
...
03-20-2018, 11:09 AM
Replies: 13
Views: 630
Posted By Atreyu'z 350

YYYup. You can get away with just a breather...

YYYup. You can get away with just a breather filter on the drivers side, but the passenger side(PCV side) should get a catch can because that side emits more oil vapor. Otherwise your engine bay will...
03-14-2018, 11:38 AM
Replies: 12
Views: 734
Posted By Atreyu'z 350

What's wrong with the DE...?

What's wrong with the DE...?
03-14-2018, 10:58 AM
Replies: 18
Views: 2,739
Posted By Atreyu'z 350

The fuel tables are different within the ECU from...

The fuel tables are different within the ECU from 2003 to 2004, and after 2004.5 the ECU uses totally different coding altogether as well as stricter emission control programming(narrow vs. wideband...
03-14-2018, 06:45 AM
Replies: 18
Views: 2,739
Posted By Atreyu'z 350

OK.. I would return that ECU and get one from a...

OK.. I would return that ECU and get one from a manual car to avoid the U1000 code and possible gear indicator readout related issues.
Forum: Media Share
03-13-2018, 07:49 AM
Replies: 8,764
Views: 714,673
Posted By Atreyu'z 350

..or have double D's. :icon44:

..or have double D's. :icon44:
03-13-2018, 06:12 AM
Replies: 18
Views: 2,739
Posted By Atreyu'z 350

From what you described, it sounds like you have...

From what you described, it sounds like you have a bad ECU. And as far as the ECU swap; I'm guessing you have an automatic..?
03-06-2018, 01:59 PM
Replies: 8
Views: 850
Posted By Atreyu'z 350

No problem.. Not at this time, but I may if that...

No problem.. Not at this time, but I may if that OEM sensor doesn't work.
03-01-2018, 06:18 PM
Replies: 15,358
Views: 1,225,508
Posted By Atreyu'z 350

Same. Sucks doesn't it..

Same. Sucks doesn't it..
03-01-2018, 10:32 AM
Replies: 8
Views: 978
Posted By Atreyu'z 350

https://cimg1.ibsrv.net/gimg/my350z.com-vbulletin/...

https://cimg1.ibsrv.net/gimg/my350z.com-vbulletin/540x304/80-ll_06346610eb5f5212ff7c3204d07890e54ff1a322.gif
02-28-2018, 10:15 AM
Replies: 15,358
Views: 1,225,508
Posted By Atreyu'z 350

Hey, Zwei. Probably just an imperfection between...

Hey, Zwei. Probably just an imperfection between the handle itself and the aluminum finish that allow moisture and other contaminants to get between.. BTW, your Z is really coming along nice....
Showing results 1 to 30 of 179
 


 
Forum Jump

Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.