MY350Z.COM - Nissan 350Z and 370Z Forum Discussion - Search Results

Notices
 
Search: Posts Made By: iideadeyeii
Showing results 1 to 30 of 139
Search took 0.01 seconds.
07-31-2018, 06:48 AM
Replies: 392
Views: 88,683
Posted By iideadeyeii

Not much of an update, but I increased timing...

Not much of an update, but I increased timing about 6 degrees a full boost across the rpm range (6psi). Clutch now slips on highway at full throttle starting around 3200rpm(my peak torque)

So, I...
07-30-2018, 09:29 AM
Replies: 10
Views: 333
Posted By iideadeyeii

Id go with the lower value Bottom says "nismo...

Id go with the lower value
Bottom says "nismo differential case" Do you have that?
06-25-2018, 07:49 AM
Replies: 11
Views: 674
Posted By iideadeyeii

Oem replacement

Oem replacement
06-07-2018, 10:43 AM
Replies: 8
Views: 479
Posted By iideadeyeii

What 500whp build has 8.8 compression? Buy a...

What 500whp build has 8.8 compression?

Buy a car already done and save yourself time/money
06-06-2018, 05:53 AM
Replies: 19
Views: 687
Posted By iideadeyeii

No-one goes that low compression unless you're...

No-one goes that low compression unless you're going very high hp(which you're not)
06-05-2018, 07:17 AM
Replies: 8
Views: 544
Posted By iideadeyeii

That's too hard.

That's too hard.
05-23-2018, 05:48 AM
Replies: 3
Views: 383
Posted By iideadeyeii

You can't tell everyone you're "riding on dubs"...

You can't tell everyone you're "riding on dubs" unless you have dubs

btw 20's look like turd on the 350z
05-22-2018, 10:24 AM
Replies: 5
Views: 421
Posted By iideadeyeii

Take the belts off and spin pulleys by hand. You...

Take the belts off and spin pulleys by hand. You will notice right away if one has a bearing problem before pulling the timing cover off
Forum: New Owners
05-22-2018, 08:06 AM
Replies: 7
Views: 450
Posted By iideadeyeii

How much do you expect to spend for the rocket...

How much do you expect to spend for the rocket bunny? :rolleyes:
05-03-2018, 10:07 AM
Replies: 7
Views: 596
Posted By iideadeyeii

What a deal

What a deal
05-01-2018, 07:21 AM
Replies: 3
Views: 467
Posted By iideadeyeii

You can tell a lot by the condition of the plugs.

You can tell a lot by the condition of the plugs.
Forum: G35/G37
04-27-2018, 09:00 AM
Replies: 2
Views: 639
Posted By iideadeyeii

Does it have gas?

Does it have gas?
04-25-2018, 07:12 AM
Replies: 37
Views: 1,410
Posted By iideadeyeii

Maybe buy a manual transmission next time? My...

Maybe buy a manual transmission next time?
My DD is a 2004 Kia Amanti with ~196k miles(which as been known to have tranny problems).

Runs/shifts perfect. Starts up with one crank. It's all about...
04-13-2018, 11:39 AM
Replies: 19
Views: 1,245
Posted By iideadeyeii

I don't understand why people create accounts to...

I don't understand why people create accounts to ask pointless questions.
04-10-2018, 05:53 AM
Replies: 34
Views: 1,711
Posted By iideadeyeii

Is there a way to download them all at once or do...

Is there a way to download them all at once or do I need to download 50 files?
04-09-2018, 11:40 AM
Replies: 18
Views: 624
Posted By iideadeyeii

The online ones were "ceramic". My audi pulling...

The online ones were "ceramic". My audi pulling my 2,000lb trailer almost couldn't stop off an exit ramp because they barely worked. Swapped to the autozone cheap pads and pulled 4,000lbs in the city...
04-09-2018, 08:57 AM
Replies: 18
Views: 624
Posted By iideadeyeii

I've had eBay pads before that caused the same...

I've had eBay pads before that caused the same issued you're having.
Switch to cheap semi-metallic pads from an actual parts store.
04-04-2018, 10:55 AM
Replies: 9
Views: 1,335
Posted By iideadeyeii

I have/use #2 for many years. No problems....

I have/use #2 for many years. No problems. Although my Z is stock height
03-30-2018, 10:39 AM
Replies: 9
Views: 564
Posted By iideadeyeii

https://turboxs.com/engine-management/121-350z-ute...

https://turboxs.com/engine-management/121-350z-utec-discontinued.html

Click on attachments.



I'd use the APS 550cc map and go from there which has "aggressive" timing parameters compared to...
03-28-2018, 11:16 AM
Replies: 60
Views: 1,856
Posted By iideadeyeii

no comment

no comment
03-08-2018, 12:57 PM
Replies: 4
Views: 494
Posted By iideadeyeii

RTV 1-minute gasket(comes in pressurized can)....

RTV 1-minute gasket(comes in pressurized can). Clean tube, put on glove, shoot rtv on finger. spread on inside of tube where head meets cover. I've used this on leaking oil pans and it worked.
02-22-2018, 06:04 AM
Replies: 1
Views: 271
Posted By iideadeyeii

Feedback & Suggestions for Our Forum This is NOT...

Feedback & Suggestions for Our Forum This is NOT a place to ask car/modification questions!
For posting feedback, suggestions or comments regarding our My350Z.com forum.
02-15-2018, 08:49 AM
Replies: 16
Views: 1,040
Posted By iideadeyeii

"Dealer-installed' Lmao

"Dealer-installed' Lmao
02-15-2018, 06:20 AM
Replies: 16
Views: 1,040
Posted By iideadeyeii

I'm definitely going to buy this very...

I'm definitely going to buy this very expensive/impractical tool kit and hold on to it for 15 years to re-sell on ebay
Forum: New Owners
02-14-2018, 06:01 AM
Replies: 19
Views: 950
Posted By iideadeyeii

Clean spark tube, get 1 minute rtv(black or gray;...

Clean spark tube, get 1 minute rtv(black or gray; it comes in an aerosol can an is about $12-18) and spread it between the tube/gasket with your finger(wear a glove), profit
02-14-2018, 05:55 AM
Replies: 22
Views: 1,700
Posted By iideadeyeii

I would say it's uncommon to have a tire mounter...

I would say it's uncommon to have a tire mounter in a residential garage, but it's not really a specialized tool since it's universal for tires. I paid $400 for the machine and use balancing...
02-13-2018, 09:38 AM
Replies: 19
Views: 741
Posted By iideadeyeii

/end thread ...

/end thread
http://www.tccoa.com/graphics/super-rice-muffler.jpg
02-12-2018, 08:46 AM
Replies: 13
Views: 503
Posted By iideadeyeii

I personally would wait unless you're getting...

I personally would wait unless you're getting wheel hop, but I usually don't fix anything until it breaks or is necessary.
02-01-2018, 07:59 AM
Replies: 2
Views: 398
Posted By iideadeyeii

You previously told us it was lowered 2" that's...

You previously told us it was lowered 2" that's why people recommended those springs since they are a 1" drop which would have increased your ride height by 1"

I told you on 01-10-2018 that the...
01-18-2018, 08:04 AM
Replies: 4
Views: 2,986
Posted By iideadeyeii

I mean. . .it's actually not a bad price, but...

I mean. . .it's actually not a bad price, but your pictures are garbage(small low res).
Showing results 1 to 30 of 139
 


 
Forum Jump

Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.