GT-Z

iTrader: (2)

Post pic's of Z's With Roll cage's

Chebosto

iTrader: (43)

you might have a better chance in the Autocross/Road Race section...

brandon3434

iTrader: (9)

Would like to see more nicely done cages other than RoyalT and Rickdogg or whoever...

BUMP

KingBaby

iTrader: (3)

Bump

I wanted to know if any one, just remove the top two speakers. leaving the sub enclosure and cubby ?

Just curious or links to a more active thread!

terrasmak

iTrader: (8)

http://www.flickr.com/photos/61208532@N05/7571886072/http://www.flickr.com/photos/61208532@N05/7571886072/ by http://www.flickr.com/people/61208532@N05/. My car

hndumafia

iTrader: (10)

Is that a custom roll bar? Doesn't look like Kirk but I don't know what auto powers looks like.

KingBaby

iTrader: (3)

On point! Thanks

Off goes them!

terrasmak

iTrader: (8)

It's a Kirk , will be for sale this winter. Moving up to a custom 6 point.

350Zdj

iTrader: (3)

Anyone with just the basic Cusco rollbar?

KingBaby

iTrader: (3)

First off hope you don't mind me stealing your pic.

In the picture above, if it had the 8 point bars that go to the driver/passenger footwell. Can the bar that goes to the side of the seats curve along the sub enclosre/cubby compartment back to the top?

Something like what I doodled below

What would be the structural pros/cons to this? reason I'm asking cause I'm 6'4 and adding a cage would make it uncomfortable to even drive. As it is now I seating position for even me is perfect.

2bad240

iTrader: (6)

i have a autopower 4 point

silverbullet_Z

iTrader: (3)

The cusco rollbar is for looks only. It's not SCCA approved. I'm sure the cusco might help a little bit (better than nothing)

terrasmak

iTrader: (8)

Nope, but you can start the bar further back. My 6 point will start about 2 inches back from the Kirk bar, mounted to the floor of the glove box/ speaker enclosure. BTW I'm 6'1 and can't drive the car with the seats all the way back with the Kirk bar installed. It has more room than stock, due to the seat design.

KingBaby

iTrader: (3)

Roger, but why? Why is it in the cage pictured above, the points in the trunk go to the floor rather than the strut bar like the Nismo? Is it rules that allow cages to vary slightly?

KingBaby

iTrader: (3)

Cause from searching the straight bar is to help in roll over situation!

Flo-ridaZ33

iTrader: (60)

Kirk Racing 4-point w/Willans harness'

350Zdj

iTrader: (3)

Thanks for the info man.

Gialli

Cardiff Motorsport






















<a href="http://www.flickr.com/photos/63717613@N02/7566853482/" title="350z34_1920x1200 von Gialli bei Flickr"><img src="http://farm9.staticflickr.com/8021/7566853482_28268a33a7_b.jpg" width="1024" height="640" alt="350z34_1920x1200"></a>

<a href="http://www.flickr.com/photos/63717613@N02/7566853790/" title="350z35_1920x1200 von Gialli bei Flickr"><img src="http://farm9.staticflickr.com/8290/7566853790_3bf7f81787_b.jpg" width="1024" height="640" alt="350z35_1920x1200"></a>

<a href="http://www.flickr.com/photos/63717613@N02/7566854050/" title="350z36_1920x1200 von Gialli bei Flickr"><img src="http://farm8.staticflickr.com/7280/7566854050_0342a039f3_b.jpg" width="1024" height="640" alt="350z36_1920x1200"></a>

<a href="http://www.flickr.com/photos/63717613@N02/7566855512/" title="350z40_1920x1200 von Gialli bei Flickr"><img src="http://farm8.staticflickr.com/7270/7566855512_0a327695ba_b.jpg" width="1024" height="640" alt="350z40_1920x1200"></a>

laze1

iTrader: (17)

Robinson Racing custom cage http://www.robinsonracing.net/

mw9

iTrader: (51)

nice pictures laze1