Momentum Performance Power Steering Cap Fitment
#1
New Member
Thread Starter
Momentum Performance Power Steering Cap Fitment
Anyone ran one of these before? just bought one, expected it to be a 5 second swap, and it sort of sux... My OEM cap does not have an O-ring, this new one came with one. The O-ring causes the cap to pop off when the air expands from temperature, but without it the cap does not seat well like the OEM one.
#2
350Z-holic
iTrader: (13)
Removing power steering all-together solves this problem...
#3
New Member
Thread Starter
Savaaaaage- I thought this cap would be a nice piece to aid my possible sale/temporary severance from racecar lifestyle (check the cars for sale section in a bit)
#4
New Member
Thread Starter
Ended up drilling a .025" pinhole at a 45 degree upwards angle out of sight and it's all good.
The cap wouldn't even sit flush when you went to push it on, let alone after it heated up, now I hear a big rush of air go through the pin hole as it seats properly.
Really questioning the momentum brand (out of biz) and moreso the place that I bought it from who said they had no issues issues with theirs...
The cap wouldn't even sit flush when you went to push it on, let alone after it heated up, now I hear a big rush of air go through the pin hole as it seats properly.
Really questioning the momentum brand (out of biz) and moreso the place that I bought it from who said they had no issues issues with theirs...
Thread
Thread Starter
Forum
Replies
Last Post
ZWingerRyRY
Forced Induction
10
07-30-2012 06:50 AM
WillyP28
North East Marketplace
2
10-16-2011 05:53 PM
chris'smax
Forced Induction
30
03-06-2009 11:04 AM