Uprev ID1000 Scaling
#1
New Member
Thread Starter
Uprev ID1000 Scaling
When trying to set my Injector Latency, I can't get it to be as close as I'd like.
Injector Dynamics lists these Latencies for 43.5 psi
14v-990
12v-1240
10v-1675
8v-2600
as close as I've been able to get it in Osiris is
14v-980
12v-1238
10v-1496
8v-1753
The 14 and 12 volts are pretty close, but the others are not. Is this ok?
I have a weird thing going on where its adding fuel at idle and low throttle input but pulling fuel like crazy everywhere else. I thought I would check with the forum to see if the latencies are ok before I go about dropping the K multiplier and adding fuel at idle... which is what I think i'm supposed to do...
Injector Dynamics lists these Latencies for 43.5 psi
14v-990
12v-1240
10v-1675
8v-2600
as close as I've been able to get it in Osiris is
14v-980
12v-1238
10v-1496
8v-1753
The 14 and 12 volts are pretty close, but the others are not. Is this ok?
I have a weird thing going on where its adding fuel at idle and low throttle input but pulling fuel like crazy everywhere else. I thought I would check with the forum to see if the latencies are ok before I go about dropping the K multiplier and adding fuel at idle... which is what I think i'm supposed to do...
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM