Work Wheels Thread
08-27-2015, 01:59 PM
#1366
Registered User
Join Date: May 2014
Location: Canada
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
18" meister s1r offset?
Ok so I'm ordering meisters s1r 18x9.5/10.5 but I'm unsure of the offset I should go with.im looking for dish. Also for suspension wise I only have BC racing coilovers and stock brakes.
08-27-2015, 02:34 PM
#1367
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
Go to the wheel section and take a look at the various setups people are running.... most representative is the Enkei wheels thread. Lots of good pics showing offset effect.
Note that this says nothing about "dish".... this rec is for performance GAIN, not just looks. If that's the priority, go to the "Aggressive tire & wheel" thread and look at the cambered cars running the extremely low to negative offsets.
Mic
08-28-2015, 04:22 PM
#1368
New Member
As Mic states in his reply, you will get a nice “flush” with 15 mm offset on the size wheels you mention in your post.
I only have experience with < 1 inch drop. If you go past that drop, you probably will need to adjust camber.
I only have experience with < 1 inch drop. If you go past that drop, you probably will need to adjust camber.
04-26-2016, 07:58 AM
#1373
kylem4 by Mark Vasquez, on Flickr
kylem3 by Mark Vasquez, on Flickr
kyle m1 by Mark Vasquez, on Flickr
05-26-2016, 03:23 AM
#1376
Registered User
Join Date: May 2016
Location: Rastatt
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Work vs-xx wheel size
Hei guys greetins from germany and sorry for my bad english 😅
I am dominik from germany and looking for new wheels but i have problems with using the right size and disk type. The german z forum cant help me well so i decided to lool here because i think the work wheels are more popular in the states.
So my problem is the choose of the real disk type and offset to fit the works with the original brembos.
The wheel size in the front should be 9,5 and 10,5 in the back. The rear fenders are rolled. I would not drive plates to fit the wheels but buy them with the right offset to fit on the z perfectly. Hope you can help me to make a good decision. Nice greetings from germany.
I am dominik from germany and looking for new wheels but i have problems with using the right size and disk type. The german z forum cant help me well so i decided to lool here because i think the work wheels are more popular in the states.
So my problem is the choose of the real disk type and offset to fit the works with the original brembos.
The wheel size in the front should be 9,5 and 10,5 in the back. The rear fenders are rolled. I would not drive plates to fit the wheels but buy them with the right offset to fit on the z perfectly. Hope you can help me to make a good decision. Nice greetings from germany.
The following users liked this post:
abarclay (05-29-2016)
