drift spares
 

Hello,

I am wondering what rims and tires fit on a 350z. I am asking this because it has been difficult for me to find anyone in my area selling their stock rims. So I was wondering does any one know what rims and tires fit a 350 z and from what car?

I think some mustang wheels fit.. look up the 350z bolt pattern, and Google search

5x114.3 PCD, +30 to +33 offset is stock for the most part.

Tons of other cars (Toyota, Honda, Mazda, Ford) use the 5x114.3 size but offsets aren't exactly suitable for Z..... many too high in > +40mm. And make sure the center hub holes are at least 66.1mm.

Trav's right, Mustang wheels are fairly close (not the newer Mustangs, those have high offset) but I think the older Mustangs (circa 2004 or thereabouts) had offsets closer on 8" wheels. BUT, I believe, largest diameter is 17.) In any event, just make sure of the offsets and hub diameters.

And by the way, don't think any Audi ever used 5x114.3.... more like the typical German PCD: 5x112 (Benz, Audi, VW)

FWIW, I have a set of Infiniti 18x8 +30 7-spoke OE wheels that'll bolt right on. If you're interested in them, PM me. This isn't an offer to sell NECESSARILY but could post up in the rollers for sale section to appease anyone offended. :rolleyes:
https://cimg8.ibsrv.net/gimg/my350z....7f2b26f328.jpg
Yes, they're different finishes.... stock on left, dipped silver on right. (And the other two may be differently finished as well, don't remember, but they'd be like the dark one on left.) I was experimenting with dip just to see what all the fuss was about. Haha.

The "piece stuck out from the hub" is a bolt that prevents you from installing the stock rear wheels on the front. You need to remove this bolt when installing aftermarket wheels.