What size spacer?
 

Im running 20 inch axis mods 20X9 +37mm front and rear, I have Falken 255-35-20 , But I want to bring there rear wheels out flush with the rear fenders, does anyone know what size HR spacer I should use, any info would be helpful thanks. Ernie

Re: What size spacer?
 

I used to have the Axis Se7en Mods in 19". I used a 20mm for the rear but my wheel width was 8". I think a 15mm or 20mm would work. 25mm may cause it to stick out.

The outside diameter of the tire sidewall is usually the widest point of your tire and wheel package. Place a straight edge flush with the face of the tire, and using a ruler measure from the straight edge to the inside lip of the fender as show in image

H&R Trak Wheel Spacers

http://www.performancenissanparts.co.../images/hr.jpg

http://members.aol.com/performancenismo/hrspacer.jpg

Re: Re: What size spacer?
 

Re: Re: What size spacer?
 

Did you have to roll the lip and do you know what the offset was? thanks

Re: Re: Re: What size spacer?
 

I didn't have to roll the lip. My offset was a +40. With a 25mm out back, the corrected offset would be +15.