Lol.

I deserve hate for even making this thread, but my question is genuine! Read on.

Currently I am NA with stock headers, test pipes, Y pipe (dual 2.5″ to single 3″), then 3″ open out the…

My 350z just got caged and up next is removing all the superfluous wiring that i don’t need. For example, the harness that goes from the rear hatch to the front (rear defroster, Bose amp, etc).

I…

Sorry for the lack of searching. Driving to the shop and gotta top off the trans very quickly before leaving. T-minus 1 hour.

My trans has basically brand new Nissan fluid in it..but when i did my…

I believe I found the biggest oil filter humanly possible for the Z.

Image: http://i1274.photobucket.com/albums/y434/Kevin_Skene/89367544-6428-4050-AEDD-87982AC71875_zpsmfinnz7d.jpg …

My connector has gone to ****. Cut it off and soldered the wires directly to the CPS sensor and my car no longer took 5 seconds of cranking to start and stopped throwing codes for bad sensor.
…

Decided to make a build thread so that all my issues can be contained.

Quick recap:

Here’s the car as I bought it for $3500: 128k, stock but had 10.5″ wide 19s and an ebay exhaust. Wheels would…

Quick recap:

After driving for a while I got the code for the knock sensor harness, bought the new harness from Z1. Took off the plenum which i’ve done 100 times (5 times) and removed the fuel…