Correct Torque Specs L19 and ARP
 

I did a search and I came up with a whole lot of nothing so...

1) what's the correct torque spec for the ARP MAIN studs?

2) Correct Torque specs for L19 HEAD studs?

I can answer the head studs....93 ft/lbs for the L19's But it is advised to do it in stages...
Bring them up to 30 ft/lbs, then work your way up in stages...50...70...93..done. The mains I am not sure. You can ask Sharif or any of the vendors for that matter.

90-95 ft/lbs for the L19
60-65ft/lbs for the ARP Mains
Both are with Moly....trq will vary if you use any other lube.

When we assemble engines, we use 65ft/lb for mains, and 95 ft/lbs for L19 head studs.

Hope that helps.

awesome! Thanks!

What about Pauter rod bolt torque specs???

Torqued to sharif's specs and holding some awesome power! Thanks!!!

there was no paper work that came with the arp goods? how much power are you putting down?

Not with L19s. They come individually wrapped and sleeved in a white padded box :)

http://www.injectedperformance.com/h..._promotion.jpg