FS: 12 DE Coil Packs, ,Osiris Uprev Tuner Version, Two-Step Control Module
#1
Banned
Thread Starter
12 DE Coil Packs, ,Osiris Uprev Tuner Version, Two-Step Control Module
SOLD SOLD SOLD 2 sets of coil packs
Last edited by Jime; 12-12-2015 at 03:45 AM. Reason: SOLD
#2
Banned
Thread Starter
Osiris Uprev Tuner Version $500 firm
$475 Shipped
All instructions and latest software available at link below. Versions change so be sure to get the latest.
Tune is on cable as shown on pic. This is the Tuner version as indicated by the "ROM Editor enabled".
http://uprev.com/secure/store/management/osiris-tuner
All instructions and latest software available at link below. Versions change so be sure to get the latest.
Tune is on cable as shown on pic. This is the Tuner version as indicated by the "ROM Editor enabled".
http://uprev.com/secure/store/management/osiris-tuner
Last edited by Jime; 12-19-2015 at 03:43 AM. Reason: Price reduction
#3
Banned
Thread Starter
Two-Step Control Module 03-09 G35 350Z $50
This cost $90 shipped, asking $50 shipped.
Holds motor RPM at preset point to lead to more consistent launches.
Key Features:
• Includes external Fail Safe hybrid relay
• When triggered this uses ignition cut to limit motor RPM to setpoint.
• Intended for manual transmission vehicles only
• Must have clutch switch installed that detects when the clutch is first pushed down (switch at bottom of travel will NOT work)
• Programmable for 4, 6, and 8 cylinder motors
• Can be upgraded to include No Lift Shift feature with only a software change (upgrade fee required)
Holds motor RPM at preset point to lead to more consistent launches.
Key Features:
• Includes external Fail Safe hybrid relay
• When triggered this uses ignition cut to limit motor RPM to setpoint.
• Intended for manual transmission vehicles only
• Must have clutch switch installed that detects when the clutch is first pushed down (switch at bottom of travel will NOT work)
• Programmable for 4, 6, and 8 cylinder motors
• Can be upgraded to include No Lift Shift feature with only a software change (upgrade fee required)
Last edited by Jime; 12-13-2015 at 02:55 PM.
#5
Registered User
#6
Banned
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
pcabutija
Pacific
0
12-08-2015 07:11 PM