My DD (Mitsu)
#21
Registered User
iTrader: (1)
Join Date: Dec 2010
Location: North Carolina
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
I went threw 2 7 bolts and a 6 bolt ( thats the one that had the 60-1) stock rebuild.O dont forget the trans, got to hate wheel hop, but had it rebuild from TRE ( check into them or shep if you ever have any transmission needs).
My diff or now office paper weight
Ima stop now I think I am getting close to hijacking status.
My diff or now office paper weight
Ima stop now I think I am getting close to hijacking status.
#26
Registered User
iTrader: (1)
Question. What made you choose the 16g over something like a t3 set up since you going for a stroker build? That thing is going to spool so freaking quick though. With the 2.3 you should be able spool a bigger turbo relatively quick. What are you going to be revving to?
#27
Registered User
Thread Starter
i had too, i put about 20k on it in the first year. i see people on the forums in here with 03 w/ 30k. i plan on keeping it forever so i will enjoy it later on and it will still have low miles.
well i got a really good deal for the turbo, manifold and fuel pump. and i decided to go with a 2.3 cuz if im gunna rebuild im only gunna do it once. i will use the 16g for a little bit, but evenually im gunna go with a bigger turbo. you can always upgrade turbos. dont wanna rev crazy but maybe like 8k
well i got a really good deal for the turbo, manifold and fuel pump. and i decided to go with a 2.3 cuz if im gunna rebuild im only gunna do it once. i will use the 16g for a little bit, but evenually im gunna go with a bigger turbo. you can always upgrade turbos. dont wanna rev crazy but maybe like 8k
#30
Registered User
iTrader: (1)
Join Date: Dec 2010
Location: North Carolina
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
Man you can street tune, there is nothing wrong with it. Hell one of the most renounced tuners I have seen street tune is stuff. Just make sure you know what you are doing and log EVERYTHING. And for the twin disk yea for high hp and good street ability but i rocked a 2600 act setup and never had an issue. I think the crank walk issues where due to the the squirters ( that feed off the mains) stick, which looses the hygroscopic wedge, causing metal on metal contact. To back this up, check with slow boy racing, they weld all theirs.
But thats my opinion ,and you know what they say "Opinions are like A$$holes, everyone has one and they all stink."
#33
Registered User
iTrader: (50)
Join Date: Apr 2007
Location: Chesapeake, VA/The Bronx
Posts: 1,747
Likes: 0
Received 0 Likes
on
0 Posts
My TH06-20G pushed out 30PSI at 3200 RPM's on my Galant VR-4.
#34
Registered User
Thread Starter
#39
Registered User
Thread Starter
ETS 12" Short Route Intercooler Kit
EVO VIII Wheel 17x8. The tires on them are junk but just purchased 255/40/17 Dunlop Direzza Z1 Star Spec from tire rack
update next BC Coilovers
EVO VIII Wheel 17x8. The tires on them are junk but just purchased 255/40/17 Dunlop Direzza Z1 Star Spec from tire rack
update next BC Coilovers