Sparcos car is on point..my next cosmetic buy will be a rear diffuser.

Havent done much to my z except stop by the shop and do a walk around about 5 times. I miss the z so much...

 

Thank you sir

 

Finally got rid of the hideous VIS hood and took a trade for an OEM 03-05 hood, it's white but it doesn't matter, I'll be painting it this week






next step: spacers, rear tails and blitz spoiler

 

Nothing really new. Gonna replace some lights in my headlights. Wet sand/buff after. New intake filter and plugs next.

 

Trade your tail lights next.

 

that's part of the plan, or either buy 06+ tails

 

HPS instake tubes

IP diff brace waiting to install

Picking up motor/tranny mounts next week from CZP

Then some maintenance and UpRev

 

Installed my radiator hose. That was a mess. Next gonna install my cf mirrors that I bought from Brandon.

 

Yesterday I adjusted my parking brake & thoroughly examined the rear underbody. My 20 x 10.5's are heavy! Today I took the Z out for lunch. I had a burger and my car had some Sunoco 93. Also I just ordered a JWT Pop-Charger with IPP's discount code I found over in the Marketplace .

 

Finally got the rear ride height set, I really hate the up and down, roll the car, measure, buck up, adjust, down etc etc. Now to get my front sway bar connected again.

Anyone else with SPL front endlinks think they are a pain in the azz? The rears are great, but for making adjustments and removing preload, they suck.

 

Still baby steppin' it. Have had my z for 2 weeks now, and I cant really decide where to start, so its going with the necessities. I just ordered a Kenwood DDX770 head to replace the crap Bose unit. Interior trim is next...

 

My 350Z won 1st place of the Z33 category at the ZCCR Motorfest show in Webster yesterday. I wasn't even looking to win anything.

 

^^^congrats!

 

Installed my Grip Royal Wheel this weekend.

 

installed my cusco strut bar

 

Hmmm...wonder if that would clear my composite plenum???

 

Installed LED's for license plate.

 

Bought some side splitters.

Wasn't long enough so I had to hack them in two.

Fiberglassed to extend the sides.

Almost ready for filler and final prep work.

 

Sunday: Prep aerosync front bumper (drill, sand, fit)

Today: Remove rear bumper and brought both aerosync and rear in for paint

While out, sanded rear turn signals with 1000grit and re polished, now not all flakey!
Also started on shifter bezel, sanded down (keeping bumps) prepping for paint for tomorrow

 

Nice sparco. What are they? (brand)