ur insane to wait to install those ^^

recreates the car, and are the best way to go too for TPs.

 

i know i know! WHen i first got em i spent the good part of a week trying to install them. I tried everything but cutting the bolts. Soaked them in loads of wd-40. pb blaster, aerokroil. i tried heating them up with my torch. I tried a long breaker bar for leverage.

My plan now, due to work constraints (deployments and TDYs) is to wait until i get my TDX exhaust from MD and just get them installed together.

 

Ive been putting off the wiper delete for months.

 

Rear Stoptch BBK, underbody bracing, painted rear bumper valencE)

 

I've got a JWT clutch/flywheel setup that has been sitting around for at least two years.

I've got an AP racing bbk that's been laying around for a little over a year.

It took me almost two years to install my SPL rear camber arms.

Hell, I've bought and sold three sets of sideskirts that never even made it onto my Z.

 

Just remove the passenger tail light, then reach down behind the bumper.

That's how I installed my driver's side euro rear fog light.

 

Apparently my whole build via the shop.

 

4.08 gears w Cusco LSD
GTR injectors
Oil catch can vented to exhaust
Zex nitrous kit (on car for 3 years, still untuned)

... not much longer.

 

Eyelids, Amp and woofers.

 

Oh man. This is my kinda thread (as of late).

I bought my wheels and tires about 2 months ago. They're still in the boxes

I had to roll my fenders (which sucked) and have to run a reasonable amount more negative camber to fit them. I haven't even been driving the car since the tires on the stock wheels are bald.

Umm... my front bumper as well. It's on the car but I had a huge falling out with the shop that painted it last Fall (and mismatched the color something horrible). So I've been disappointed with the car in general, though I'm slowly getting it back to where I want it to be.

Oh, and my factory Bose HU stopped working over a year ago. I have another one sitting collecting dust at home. Ugh.

 

I picked up a set of BattleVersion toe arms and SPL eccentric lockout washers 2 months ago and I haven't installed them because I don't feel like driving 45 min to get an alignment :/

 

side skirts, megan lower tie brace, and chargespeed rear have been in my garage for a good 8-9 months now u.u

 

Looking to sell?

I suppose it's worth a shot... lol

 

Took me 9 months to install my Nismo V2 bumper , I still need to fab up the splitter and cut in the scoop for the saddle mounted oil cooler. Oh I still need to move the oil cooler to its new position.

 

dislike

 

I'm not sure yet. It depends if I pick up another clutch setup that I've been considering.

If I do, I'll let you know.

 

I've set no deadlines, I got stuff "pigeon-holed" all over my garage, I do get some items installed when I get around to it. The only one thing that will most likely "not" install is the
two air intakes for I cannot put my front bumper under the utility knife. a lot of progress has been made though.

 

Sounds good!!

 

On another note, believe it or not, I worked on the Z for about 5 hours last night. Got the wheels on and they look siiiiick! Just got to get it in the shop on Saturday and get it fine tuned. Pretty excited!

 

The name says it all.