Getting another Z! Mod ideas?
#62
General & Tech Moderator
MY350Z.COM
MY350Z.COM
I clean my fuel injectors w Texas Pete.
Last edited by jhc; 08-04-2015 at 07:56 AM.
The following users liked this post:
slow7 (08-03-2015)
The following users liked this post:
jhc (08-03-2015)
#66
Registered User
Getting another Z! Mod ideas?
Bennis, I'm sorry did you just say that there is a TT kit for 1.2k? I'm going to refrain from being insulting due to my assumption that you are young. You will spend a thousand on a good turbo. That's one (1) single turbo. The lowest price I have ever seen for a TT kit is $6950. Please for the love of God, before making another post, provide us with a link to a bolt on twin turbo kit for less than 5k.
The following users liked this post:
slow7 (08-03-2015)
#71
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
One big ****.... lag's is a bit of a pain but it's cheaper.
#72
General & Tech Moderator
MY350Z.COM
MY350Z.COM
...
Last edited by jhc; 08-04-2015 at 07:54 AM.
#74
Master
iTrader: (8)
here is a good kit for 5900..... whoever said 1200 would be "special" if the trusted that kit
https://my350z.com/forum/turbos-nitr...w-nor-cal.html
https://my350z.com/forum/turbos-nitr...w-nor-cal.html
#75
Registered User
So i want to run 4 of these and get 3k hp, problem is, i also am concern of the weight. Cause weight reduction is better than hp, thats kinda why i took the engine and tranny out of my csr in the first place. Nothing but dead weight.
The following users liked this post:
slow7 (08-04-2015)
#76
New Member
iTrader: (9)
Ps. I don't think you're dumb.
The following users liked this post:
slow7 (08-04-2015)
#77
Registered User
Are you new here? Or just dumb? Open the bag (just a crack at the corner) and push all the air out, this is affecting space and weight. Once you do these and scotch tape them close (pins are too heavy) you should have a nice balance between weight and power.
Ps. I don't think you're dumb.
Ps. I don't think you're dumb.
Ps: you didnt have to say you dont think im dumb, its all fun and game here haha
The following users liked this post:
slow7 (08-04-2015)
#78
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
Hey, T'bo, don't forget to re-pack your muffler bearings while doing the helium swap.
#79
Registered User
#80
Registered User
iTrader: (2)
here is a good kit for 5900..... whoever said 1200 would be "special" if the trusted that kit
https://my350z.com/forum/turbos-nitr...w-nor-cal.html
https://my350z.com/forum/turbos-nitr...w-nor-cal.html
Not like I've ever tried to DIY a turbo kit, and not like I was very unhappy in the end with working on it/how it fit the car/carb BS
This kit will net you 1200hp, if you reinforce the rods with quik steel, reinforce the sleeves/fill the coolant system with cement, and jbweld the head to the block. Good to go m80.
http://www.ebay.com/itm/like/230918056611?lpid=82&chn=ps