I was bored one day and had some sheet metal lying around so i decided to start fabricating a lip for the z. what you guys think?




Its not fully painted yet. Its in 3 pieces cuz the sheet metal i had wasn't big enough, but I think ive hidden that area well. Its fitted on with 14 bolts under the bumper. The only major problem it has is one side slightly bends upwards (idk if you can see it in the pics). yall got any idea on how to fix that bend?

 

I would of spend the time wet sanding and buffing your front bumper instead, but the lip itself should compliment the bumper's lines and it does not in this case.

 

O sweet.. I was going to do the same thing, if I had extra I was going to make a custom widebody and get huge spacers.

 

 

 

It honestly looks horrible and you can tell its home made with about 20 minutes of effort... But its your car so as long as you like...

My opinion it makes the front bumper look like trash.

 

You're going to be slicing up some ankles. I just use lips off other cars and make them fit mine. I made a STi lip fit the oem Nismo bumper.

 

 

 

It might help a bit if you trimmed it off with some rubber trim, but like the others have said it looks to homemade!! Back to the drawing board!

 

Since you asked for opinions, mine is that it looks horrible. It's probably going to be a good spark generator, so I hope you don't have any fuel leaks. Maybe some curb feelers might add to the appearance.

 

That car probably auto drove itself into a wall already.