Wiring Color code Guide for 350Z
I did a search and didnt find such a post, admins, if you want to sticky this, feel free, if its already been covered, sorry, and you can delete this post :)
color guide for alarm related: category color polarity location 12volts white/blue + ignition harness Starter white/red + ignition harness Second Starter white/green + ignition harness Ignition black/red + ignition harness Accessory white/black + ignition harness Keysense black/red + ignition harness Power Lock red - driver door module in door Power Unlock lt. blue (double pulse) - driver door module in door Lock Motor purple 5wi white plug, pin 30 at BCM Unlock Motor yellow 5wi white plug, pin 23 at BCM Disarm Defeat white/red 5wi white plug, pin 31 at BCM Parking Lights+ red/blue + driver kick panel Hazards green/red - brown plug, pin 61 at BCM Turn Signal(L) green/white + white plug, pin 22 at BCM Turn Signal(R) purple/white + white plug, pin 21 at BCM Reverse Light lt. green + driver kick panel Door Trigger white (L), pink (R) - white plug, pin 14, 10 at BCM Dome Supervision comes on with unlock Trunk/Hatch Pin red/white - white plug, pin 18 at BCM Hood Pin lt. green/black - hood pin switch under hood Trunk/Hatch Release pink - brown plug, pin 76 at BCM Factory Alarm Arm arms with lock Factory Alarm Disarm disarms with unlock Disarm No Unlock single pulse power unlock wire Tachometer NOT white/blue or black ac any ignition coil Brake Wire pink/blue + brake pedal switch Parking Brake purple - parking brake switch Horn Trigger green/black - steering column navi: Speed Sense white 8P Unified Meter and A/C Amp, pin 26 The Unified Meter and A/C Amp is behind the A/C controls in the center console. audio: Radio 12v yellow + radio harness Radio Ground (chassis) Radio Ignition lt. green + radio harness Radio Illumination red/blue + radio harness Factory Amp Turn-on green/yellow + radio harness Power Antenna green/white + radio harness LF Speaker +/- blue/red - black/white +,- radio harness RF Speaker +/- yellow/red - red/white +,- radio harness LR Speaker +/- lt. green/red - black/yellow +,- radio harness RR Speaker +/- blue/orange - black/pink +,- radio harness all wiring guide courtesy of DEI |
I haven't verified it with the info that you posted, but I ran across some differences in the wiring and pin numbers from the 2003/2004 and the 2004.5 Zs. I don't know if the wiring has stayed the same from the 2004.5 thru the 2005 & 2006 but I suspect it has.
So depending on what model year you have, those colors and pins may or may not be correct. |
dave, thans for the heads up, tis was pulled from a guide for 04, but if you know some difference, please post them :)
the easiest way to verify is with a test light that test for ground :) |
Thank you for saving us a dome light relay! Too bad Nissan doesn't specify each IO's operating current/voltage levels. For circuit protection Schottky diodes have a lower voltage drop than generic diodes. Mechanical relays compromise reliability, so minimize their use. Use a DVOM instead of a powered test light to reduce airbag risk. :eek:
|
For just the alarm install subset (there may be more deltas, or even the 2004.5 manual may be wrong) I found seven discrepancies noted by ">>".
***Trained Technicians must first DVOM validate definitions, as a mistake could easily cause a very expensive short. :icon20: *** Hazards green/red - brown plug, pin 61 at BCM >>29 Turn Signal(L) green/white + white plug, pin 22 at BCM >>45 Turn Signal(R) purple/white + white plug, pin 21 at BCM >>46 Door Trigger white (L), pink (R) - white plug, pin 14, 10 at BCM >>62, 12 Trunk/Hatch Pin red/white - white plug, pin 18 at BCM >>57T / 58H Trunk/Hatch Release pink - brown plug, pin 76 at BCM >>30 (The BCM's connector count is 70...) |
2 Attachment(s)
What dream724Z has observed is not that the 2004.5 manual is wrong, it's a different BCM connections.
Here's what I have for 2004.5 (and possibly 2005) BCM 12V constant supply (fused): gray 42 at BCM Ignition ON: white/blue 38 at BCM ACC ON: light-green 11 at BCM Driver's door switch: white 62 at BCM Passenger's door switch: pink 12 at BCM Rear Hatch switch: red 58 at BCM CAN data: blue 39 at BCM & pink 40 at BCM Ground black: 52 at BCM Door lock actuator: purple 50 at BCM Driver's door unlock actuator: yellow 44 at BCM Passenger's door unlock actuator: white/red 51 at BCM Rear hatch actuator: purple 68 at BCM Here are the connector diagrams for the 2003/2004 and 2004.5 BCM. |
Nissan 350Z service manual color code.
B = Black W = White R = Red G = Green L = Blue Y = Yellow LG = Light Green BR = Brown OR = Orange P = Pink PU = Purple (Magenta) GY = Gray SB = Sky Blue (Cyan) CH = Dark Brown (Chocolate) DG = Dark Green When the color is striped the base coler is given first, followed by the stipe color as shown here: L/W is Blue with a White stripe. |
Damn Bing I just realized that you posted this thread, thanks! I am hooking up my S2000 push button start right now thanks to your wiring diagram for the 03's =p
I have the carputer all wired up and ready to go too. I will call you when I get some time so we can tune this bad boy :icon38: -Prashant |
(sorry double post)
|
I'm sure someone in here can tell me what wire to splice in to get 1.21 gigawatts of power for my flux capacitor?
well if not that, can one of you tell me: 1. whether the Z's power seats use constant power or are only powered when the key is in the "on" position? 2. how much power does each seat require? 3. since my Z doesn't have a stock harness for this, what wire can I splice into to get the necessary power and if I do need a remote should I just go directly to the fuse box? thanks. |
If you want the wiring colors for any car, you should check out this site:
http://bulldogsecurity.com/ they cover most vehiles and there no registration necessary Update, they have included a 2003-2005 Nissan 350z wiring diagram |
Funny how they have Skyline GTR but no 350z haha
|
Thanks for the great reference!
Can you add a key to describe what your text means? For instance I am looking the illumination wire and you say: "Radio Illumination red/blue + radio harness " I think you mean: Signal: Radio Illumination Wire Color: Red with blue stripe Location: Radio Harness The problem is there is no red with blue stripe so I'm clearly wrong in my interpretation of your guide. Can someone please clarify this FAQ for us that don't know what the heck it means? Thank you in advance! <edit> Yes, I was correct in my assumption of what he was trying to say and the correct wire was just pointed out to me and it is in fact red with a blue stripe. It turns into orange on the radio wiring harness so thats good info to know for other n00bs like myself. |
White Wire for the PAC SWI-X
Anyone know where to connect the WHITE WIRE of the PAC SWI-X in a 2006 Z?
|
Since this subject comes up twice a month ...
|
Anybody know which wire is for the reverse lights in the BCM for an 06?
|
i think somebody needs to post a diagram for the 06.
|
I am re-doing my car pc setup using a carnetix P2140 regulator. This regulator has an input for turning on with a pulse (from 0 or floating to 12V) (http://www.carnetix.com/installation...anual_V1_2.pdf section 6) for use with an alarm system.
Would I be able to tap in to the light blue unlock wire to get the signal that I need? I checked it out with my multimeter and it looks like it is normally at +5V. I am guessing that it pulses low when I unlock the door, but it is too quick for my multimeter to pick up. So it looks like, for this to work, I would need another constant +5V source and a relay? If I can do this, is it a bad idea? |
check this place out http://www.aubreyandcharles.com/NissanServiceManuals/
|
so these wire colors anywhere in the car are what the guide says they are or only for certain places in the car
|
All times are GMT -8. The time now is 11:05 AM. |
© 2024 MH Sub I, LLC dba Internet Brands