The situation:

I installed the USA-SPEC Ipod interface to my factory radio.

Things that I unplugged during the install were:

(1) 3 pod gauges harness (multi,oil,volt)
(2) factory navigation harness
(3) ofcourse, radio harness

After everything was plugged back in and put back the dash assembly, I tested the ipod interface, it works fine so I drove.....

Now the problem:

Things that stopped displaying on my gauge:

-turn signals + hazard doesn't display on my gauge (green arrows), but it works and blinks

-high beam works but it doesn't display on my gauge (blue light indicator)

-trip odometer (a and b) displays *not* the mileage, it always resets to zero (0) every time I start the car NOW. It used to record the whole driven miles unless I hold the button to manually reset. I do it every gas pump.

-TPS is always on now, never did it before


WHAT IS WRONG HERE ? THANKS IN ADVANCE GUYS!

 

moderator please close this thread. dealership took care of it free of charge.

 

Anyone know the answer to this? Im having the exact same problem.