raised lettering on sub box
#1
Registered User
Thread Starter
raised lettering on sub box
I am getting ready to build my Gf a sub enclosure for her 03 350z. I am debating between fiberglass front or just a carpeted front. Id really like to do a fiberglass front and paint it the same color as her car (brickyard). Anyway my question is if I was to do fiberglass how can I get the "Fairlady Z" logo in it. I know I could just paint it on there but I would kinda like to have it raised a little bit. Hope that makes sense.
Basically the enclosure will be for 1 JL 10. under rear strut bar housing like a lot of them are. It will be flat faced on the sub side of the box but instead of wood it will be fiberglass with the "Fairlady Z" logo under the sub. Id like the "fairlady z to be raised from the flat surface a bit. Thanks for any help yall can give.
Basically the enclosure will be for 1 JL 10. under rear strut bar housing like a lot of them are. It will be flat faced on the sub side of the box but instead of wood it will be fiberglass with the "Fairlady Z" logo under the sub. Id like the "fairlady z to be raised from the flat surface a bit. Thanks for any help yall can give.
Thread
Thread Starter
Forum
Replies
Last Post
Gruppe-S
Body Interior
13
05-16-2016 10:42 PM
CFAUVEL
Exterior & Interior
3
10-01-2015 03:20 PM