harness mounting
#1
Thread Starter
Registered User
iTrader: (51)
Joined: Oct 2006
Posts: 2,405
Likes: 5
From: cincinnati
harness mounting
I am planning on getting the Schroth Hybrid II for the Z. I have the BCR harness bar and a sparco PRO 2000 seat. I was looking at this page on the mounting angles, http://www.schrothracing.com/docs/Co...structions.pdf. My question is that, how my setup is, is my angle would be about 20 degrees up, instead of down as in the instructions. Would this angle be acceptable, or am I going to have to change my harness bar so I can get the belts more parallel or 20 degrees down. It looks like the BCR and Sparco harness bar would be the same. I am thinking about getting my buddy just to make me a new harness bar so I can get my belts at a better angle as in the pictue.
#2
scca has a good writeup of how to mount the harness bar
http://cms.scca.com/documents/Club%2...CR/2009GCR.pdf
http://cms.scca.com/documents/Club%2...CR/2009GCR.pdf
Thread
Thread Starter
Forum
Replies
Last Post
Tonyz_2004_350z
South East Marketplace
1
10-04-2015 12:53 PM