Any available seat rails and/or seats for an R32 GTR?

 

1. The sliders come with the seats. If you mean seat brackets, they are sold separately and are custom made locally.

2. I'm actually not totally sure. I could provide you with any measurements you may need to determine if it is or isn't. You could also provide me with the info and I could compare it for you. Also, our brackets may be slightly lower than stock so you may gain some room there. We sold a set to a local 350Z owner and he had no issues and he was probably around 5' 10" to 5' 11".

Let me know what you need to help you determine if ours will work for you.

 

Yes, we have the seats and seat brackets that will work with the R32. We've had our seats in a R33 as well.

 

Ha..yes..no problems as to me that's short..
I'm 6 4.

I'll check.

 

Yea, you're tall lol.

Once you get me the measurements I'll talk to my welder to see how low he can get the brackets.

Just to give you an idea, the cushion height is 3 3/4" towards the rear of the seat and 6" at the highest point at the front. This is without the sliders or brackets, just raw cushion height.

 

K.. I'm using mobile right now...but did you offer leather or can you do custom material by chance? (Ie do u manufacture them directly?)

 

PM'ed!

 

We offer PVC leather, not real unfortunately. We can do custom materials as long as we have access to the specific material.

Typically it can take 4-6 week for custom pieces to get to us though.

 

Can you confirm this 100% for me? I don't see it in the applications list and I don't want to deal with the hassle of sending back a product. I'm stationed in Japan, through an APO address.

 

Based on our welder it will work 100%. Basically the S13 brackets should bolt straight on according to him. From some research online, people have pulled R32 seats into S13s with one slight modification to one of the tabs. I assume that the S13 bracket should fit doing the same sort of modification but in reverse. [Supposedly getting the R32 seats to fit requires re-drilling one of the tabs to fit into the S13]

The safest bet is to give me the distance between the actual mounting holes off the floor pan and then I can have the welder make it exactly to that so there is no guess work.

 

Bump

 

bump

 

bump

 

bump

 

bump

 

bump

 

bump

 

bump

 

bump

 

Check out our new seats. They will be available in Q4 2011. Pre-order available as well as customizations at an additional cost.