Looking for a place to turned my stoptech rotors
Thread Starter
New Member
iTrader: (14)
Joined: Jun 2006
Posts: 228
Likes: 3
From: Claremont/Pasadena
Looking for a place to turned my stoptech rotors
Hello everyone,
I need to get my aero stoptech cross drilled rotors turned. My rotors need this procedure because they are not smooth anymore. They are out of my z and seating on my workbench.
I am located in the San Gabriel Valley in S. Cal. Oreillys are known to do it but I do not trust those guys for this particular job.
If you know of a good shop, please advice!
I need to get my aero stoptech cross drilled rotors turned. My rotors need this procedure because they are not smooth anymore. They are out of my z and seating on my workbench.
I am located in the San Gabriel Valley in S. Cal. Oreillys are known to do it but I do not trust those guys for this particular job.
If you know of a good shop, please advice!
Last edited by photo2u; Jan 2, 2018 at 03:41 PM.
Thread Starter
New Member
iTrader: (14)
Joined: Jun 2006
Posts: 228
Likes: 3
From: Claremont/Pasadena
I took my rotors to Oreillys in Glendora. The tech, Robert did an EXCELLENT job turning them. I am very happy with the results. I think the stoptech rotors are way overpriced. The "hats" used on the aero rotor's go for an average of 325? The actual friction rings are way more. It safe to say, I would not be buying stoptech products in the future.
Last edited by photo2u; Jan 5, 2018 at 08:44 AM.
Thread
Thread Starter
Forum
Replies
Last Post