View Poll Results: Would you buy these arms?
If the arms cost around $900, yes I would buy them
8
40.00%
No, I wouldn't buy these arms
12
60.00%
Voters: 20. You may not vote on this poll
Battle Version 350z caster arms - prototype
08-22-2006, 02:03 PM
#1
Sponsor
Performance Nissan
Performance Nissan
Thread Starter
iTrader: (3)
Join Date: May 2006
Location: Duarte, CA
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
Battle Version 350z caster arms - prototype
For those of you that have been looking for a way to adjust your caster on your Z33, check this out:
Alex came by to show us the prototype shown above. As with all his products, he utilizes a beefy Aurora spherical bearing and reinforced the welded joint with additional aluminum for durability and strength.
If you have seen the Nagisa Auto arms, they are very similar however the Battle Versions have a bit more reinforcement where the spherical bearing end is welded on and use a more superior bearing.
At the moment pricing is not available. Basically Alex wants to get some feedback and check the interest level.
More pics can be found here: http://www.mynismo.com/products/?id=5556
Alex came by to show us the prototype shown above. As with all his products, he utilizes a beefy Aurora spherical bearing and reinforced the welded joint with additional aluminum for durability and strength.
If you have seen the Nagisa Auto arms, they are very similar however the Battle Versions have a bit more reinforcement where the spherical bearing end is welded on and use a more superior bearing.
At the moment pricing is not available. Basically Alex wants to get some feedback and check the interest level.
More pics can be found here: http://www.mynismo.com/products/?id=5556
08-22-2006, 03:00 PM
#2
I'll take one whenever it comes out.
I've been looking at the Nagisa Auto ones and ALMOST bought one (biggest problem was that they weren't exactly selling them yet).
So put this thing on the market, price it anywhere lower than the Nagisa Auto ones (which are through the roof expensive) and you have one buyer right here, no questions asked!
I've been looking at the Nagisa Auto ones and ALMOST bought one (biggest problem was that they weren't exactly selling them yet).
So put this thing on the market, price it anywhere lower than the Nagisa Auto ones (which are through the roof expensive) and you have one buyer right here, no questions asked!
Last edited by 21112; 08-22-2006 at 03:10 PM.
Trending Topics
08-29-2006, 06:52 AM
#14
Originally Posted by jinsei888
please make it! I can adjust caster for wider wheel front clearance during rebound/compression along with the camber!
08-30-2006, 07:21 PM
#18
New Member
Originally Posted by Gsedan35
Curious what everyone that is asking for these parts to be made has in their mind as a new go to number. Most oem car's are at 7 to 8 degree's. What number will you go to?
I wanted to come out of that TSB with equal steering response in both directions, when it turns out that's not the case. So something that allows me to set caster will give me an option for dealing with this (although I remain disappointed, still after 4 years, that I own a 'performance' car that came from the factory without the ability to adjust caster or camber in the front.)
