I'm installing SPL upper control arms on the the Z, but don't have a service manual, and the parts didn't come with any instructions. I'm just looking for the torque numbers. Can anyone help me out?

Thanks!

 

All I can tell you is on my SPC arms the top nut was set to 120lbs. The other two I couldn't tell you. I thought they were around forty something. I believe I might still have the instructions at the house to check. I'll get back to you if no one else does.

 

prolly just german spec

 

Hi,

Torque specs are listed within this page:

http://www.splparts.com/doc/SPLFCAZ33/default.htm

 

Thanks.
I must have looked for the instructions page over 5 times and could'nt find it. Now that you sent me the link, I can see it at the bottom of the page. Not sure how I missed it before.

I think I overtightened the adapter cone nut (45+ ft-lbs)