So I just got finished installing my new AAM angled spacer and I was trying to replace the strut tower brace. I thought this would be the easiest part, but it turned out to be quite difficult. It took quite a bit of trial and error to get the bar adjusted so that it would fit back on the bolt. But then I had even more trouble trying to get the bolts to catch. I'm afraid that I may have been stripping a few on the driver's side. I ended up quitting and leaving 2 bolts off and 1 loose. I'm going to see if the mechanic can do a better job than I did when I get my Brembos installed.

 

Just use some washers as spacers and it will fit fine. I have the AAM spacer as well and had to space my JIC bar.