please take a lookie
#1
Registered User
Thread Starter
iTrader: (5)
Join Date: Jun 2004
Location: Phoenix
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
please take a lookie
So long story short i want to add negative camber to the front but i do not have aftermarket control arms...how do i do this? I searched for DYI camber adjust on stock arms and did not find anything. Any info would be appreciated. Car is currently lowered on some tanabe springs and left front tire is rubbing against fender lining when driving (constantly unless wheel is turned)> i want to get rid of this asap!
Thanks
Thanks
#2
Know it all
iTrader: (6)
Join Date: Nov 2008
Location: Dallas (Colleyville), Texas
Posts: 695
Likes: 0
Received 1 Like
on
1 Post
Roll your fenders, or go have an alignment done and tell them you want this much degree of negative camber. Or if you happen to have 20" rims, sell them and buy a set of 18" or 19" rims.
#5
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
You want to look like you ballen on 20's yo , don't be cheap and go buy some camber arms yo.
Either buy camber arms or remove the ghetto size SUZ wheels.
Either buy camber arms or remove the ghetto size SUZ wheels.
Last edited by terrasmak; 05-02-2009 at 03:04 PM.
#6
Registered User
Thread Starter
iTrader: (5)
Join Date: Jun 2004
Location: Phoenix
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Front control arms have been ordered and this thread can be closed.
thank you
Thread
Thread Starter
Forum
Replies
Last Post