Was having some fitment issues with AAM Plenum spacer (thanks for the T-shirt guys) and in the process disconnected MAF sensor to work easier, well I wasnt paying attention when I fired it up to see if fitment issues were taken care of. Long story short car ran for bout 20 seconds without MAF plugged in, shut it off, plugged it in. Car runs fine now but SES light on. Is there an easier way to clear that without doing the whole gas pedal thing? Before I get flamed yea I know I'm an idiot for forgetting that.

 

Take it to Autozone they will clear it for nothing..

 

Really?? Will that effect my reflash??

 

Just run it for a few days. It should go away. I had a check light after installing my JWT pop charger. Drove it for a day and a half and it went away.

 

The SES light will turn off after a few successful starts. The gas pedal procedure is pretty easy as well once you get the timing down.

 

Many thanx guys, I'll leave it alone for now.