So I'm replacing my clutch and flywheel. Currently have those reinstalled and am about to put my tranny back in.

But I'm a bit hesitant about doing so due to the throwout bearing. Essentially, I have the throwout bearing back on attached to the clutch fork, and on the spine.

My question is, the throwout bearing now doesn't get pulled back into place if I move it, like it did before. Did I do something wrong on my install? Or is that simply because there is no pressure on the clutch fork now from the clutch line?

 

I hope you have this figured out by now, but yes. I believe the cone shaped part on the clutch is what pushes the fork back when you release the clutch lever. I'm no expert Though.