Z1 Plenum Spacers $162 + Shipping
#127
Registered User
Join Date: Feb 2005
Location: Savannah, GA
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
Just posted a how-to for the install, in case anyone was hesitant. Very simple!
https://my350z.com/forum/engine-driv...ml#post6974304
https://my350z.com/forum/engine-driv...ml#post6974304
#128
Just posted a how-to for the install, in case anyone was hesitant. Very simple!
https://my350z.com/forum/engine-driv...ml#post6974304
https://my350z.com/forum/engine-driv...ml#post6974304
#132
Registered User
hmm, tempted to get this vs the MD 5/16th one. Your price is better but I'm worried about the angled aspect.
What is the thinnest dimension? Is the highest dimention 5/16"?
Are you worried about bending the long screw a bit since due to angulation, the path of the screw from upper plenum, to spacer, to lower plenum will not be 100% straight?
Maybe I'm overworried about it, but the last thing I need is air leakage.
Very tempted though, great price.
btw, how does the material differ from MD one?
tx
What is the thinnest dimension? Is the highest dimention 5/16"?
Are you worried about bending the long screw a bit since due to angulation, the path of the screw from upper plenum, to spacer, to lower plenum will not be 100% straight?
Maybe I'm overworried about it, but the last thing I need is air leakage.
Very tempted though, great price.
btw, how does the material differ from MD one?
tx
#133
Registered User
Join Date: Feb 2005
Location: Savannah, GA
Posts: 347
Likes: 0
Received 0 Likes
on
0 Posts
The thinnest part of the spacer (rear) was about 1/4"... it's angled, but not very much. The top bolts threaded in without any problems, I wouldn't worry too much about it.
Thread
Thread Starter
Forum
Replies
Last Post