When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
is there space to put that inside the fender, and since u have a vent, it might flow out and allow adequate cooling.. just wont be as effective as putting that thing in the front of the nose for maximum air flow-.
our IC is pretty much over kill anyway when it comes to the amount of boost we're running.. i think if u put in infront of the IC, you'll be ok..
you dont want to cut the aerosync do you?
I think I can mount it in front of the intercooler without cutting - won't be sure until the areosync arrives - of course, above the bumper would require cutting - I am very hesitant about that as it might end up looking odd. The fenderwells are full, and no place to relocate anything. This is a very tight engine compartment, to say the least. Worst case maybe I can relocate the radiator expansion tank to above the bumper using an aftermarket tank - then put a oil cooler where it was in the fenderwell.
After trying to contact Mr. Motorsports, with no responce, I contacted Amazon.com, they told me they would check it, the next thing they refunded the money. Back to square one.
03-16-2006, 02:17 PM
oo!
