pics of GB doluck
Originally Posted by leeboyNY
Yeah, that doesn't look bad.. Even genuine kits need some fittings.. A little tug here and pull there will take care of the tabs being short. As long as the bumper isn't warped and has lots of wrinkles on the flat surfaces, it's considered pretty good...
Originally Posted by Chebosto
wow. what's punkster saying about it?
im working with the manufacture to see what is going on. Im waiting on the original bumper pics to get back to me. Im also asking them to take some side by side pics.
Thread Starter
Registered User
iTrader: (25)
Joined: Aug 2004
Posts: 4,402
Likes: 0
From: Goochland , VA
Originally Posted by Z1 Performance
you must be looking at vastly different pics - that bumper is "shrunken" - very common with poorly constructed molds
If you guys want me to take pics of what the authentic Do-Luck rear fitment is like, I'll do what I can to help out. The Authentic one has a slight mis-fitment on the driver's side tab, but that's the ONLY mis-fitment on this entire kit, the rest is super flush. These pics however... I'm not too sure buddy!
Originally Posted by abui01
If you guys want me to take pics of what the authentic Do-Luck rear fitment is like, I'll do what I can to help out. The Authentic one has a slight mis-fitment on the driver's side tab, but that's the ONLY mis-fitment on this entire kit, the rest is super flush. These pics however... I'm not too sure buddy!
would it be possible to take some pics and give me some measurements?
Here is the measurement of the authentic one i have at the manufacture
Thread
Thread Starter
Forum
Replies
Last Post
350Z_Al
Exterior & Interior
133
Oct 29, 2020 07:44 PM
ars88
Zs & Gs For Sale
18
Apr 4, 2016 07:52 AM
Tochigi_236
Feedback & Suggestions for Our Forum
8
Sep 27, 2015 03:40 PM