Grille Fabricators-pls Help
10-27-2007, 05:41 PM
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Dec 2004
Location: tucson.az
Posts: 638
Likes: 0
Received 0 Likes
on
0 Posts
Grille Fabricators-pls Help
I recently installed a Stillen Series 2 front end. It fits nicely, looks great, but the large opening in the center as well as the openings on the sides reveal too much and look unfinished. I am N/A and thus no intercooler to hide the "stuff".
Stillen says it has no aftermarket grille for this non-FI application.
I know I can go to Home Depot and buy chicken wire, cut it to fit, rattle can it, and band-aid it on. I also know it will look cheap and jerry rigged.
Is there anyone here who can fabricate grilles and fasteners that look professional? Any help/guidance would be sincerely appreciated. Thanks.
Stillen says it has no aftermarket grille for this non-FI application.
I know I can go to Home Depot and buy chicken wire, cut it to fit, rattle can it, and band-aid it on. I also know it will look cheap and jerry rigged.
Is there anyone here who can fabricate grilles and fasteners that look professional? Any help/guidance would be sincerely appreciated. Thanks.
10-27-2007, 06:27 PM
#4
Registered User
Thread Starter
iTrader: (1)
Join Date: Dec 2004
Location: tucson.az
Posts: 638
Likes: 0
Received 0 Likes
on
0 Posts
I'm looking for help from experienced sheet metal/pierced metal fabricators; Pics of the Stillen Series 2 are readily available @ the website-w/ intercooler. Obviously no pics of non-intercooled, otherwise I would not have posted. Do want pics of my unfinished front end? I don't see how that would help me find someone who could help.
Thread
Thread Starter
Forum
Replies
Last Post
