Hello all, I was wondering if anyone who has installed this particular shift **** has done so with the Tommy Kaira Shift **** Finisher as well. I have seen one posted with a Nismo Shift **** Finisher but not with the TK finisher. I have it and it looks a little odd in my car, If anyone has doen this and has a pic so I can see if I actually have it installed the right way that would be cool. Thanks alot guys and sorry if I missed it somewhere in this forum. Thanks again.

 

https://my350z.com/forum/exterior-and-interior/314064-tommy-kaira-shift-knob-installed-pics-jdm-warning.html

 

Yeah that is the one with the Nismo finisher from one of his old *****.

 

I have a tk shift **** and see no need for a finisher...

 

I purchased the Zeetoyz, metal finisher for my TK ****. I havent had a chance to see what it will look like, but I think it will look much nicer then the rubber sink washer.

 

are you talking about the finisher that visionaryracing is selling? if so, it is not a TK finisher. It looks to be the exact same finisher that Zeetoyz is selling and doubt it will look very good with this ****.

I would suggest using a small rubber grommet type and just trim it very thin. Or, take the the section off that contains the shift boot and stack a few rubber washers underneath the boot to lift the boot up to the bottom of the ****

 

Yeah thats the one. The main reason I asked was because I ordered the Aluminum Finisher and it works great and looks great, the only problem is that it is a different color than the TK shift ****. The finisher is brighter than the shift ****. Other than that it is awesome. I just wanted to ask...