Hello, all. I've looked around and I don't see anyone that sells a crash bar for the 350Z that will allow space for a FMIC. The instructions in the Greddy kit say to cut the factory one, but i don't want to go thru all that unless there are no other options.

Ideas? I really want to run with a crash bar due to the fact it wont take much to put the FMIC into the engine.

If you have troll responses, go elsewhere. Seriously.

 

Are there any offroad fabrication/welding shops in your area or do you have any friends who weld? It wouldn't be hard for them to mock/cut up some mounting plates and fabricate a simply tube bumper that would have more than enough clearance.

 

The few i know of are either overly expensive OR terribly inadequate. Im 10 min from Forged and about 45 from Z1.