I'm in the process of stripping my 2008 350z touring an don't want to run my passenger seat till I get racing seats (nobody rides with me) but the air bag light is on I got resisters to trick the system but everybody is saying to find the yellow plug I don't have a yellow plug I do have a grey plug one with a blue wire an yellow wire but that's on the seat the seat isn't going back in my car (unless my girlfriend decides to go on a cruise which is highly doubt full)
I'm assuming I need to put the resistors in one of the 3 plugs on the floor
so please help me

 

It's more than just resisters for your passenger seat. First did your seat have airbags because it doesn't sounds like it did?

The problem is replacing the weight sensor in the passenger seat which I don't think is possible in an 08.

There is a thread on the forum about this but I don't know where it is.

 

It doesn't feel like it does but I can't find anything for my car to fix the issue I guess I'll just run around with the light on

 

It sounds to me like you just have to complete/close that circuit loop. Inserting a resistor is actually contrary to what you're trying to accomplish...

 

Yeah I just don't know what one to out the resistors in I wounder if it will hurt for me to just start putting resistors in the 3 plugs till it goes away but I don't want to make my airbag go off ether