Anyone put the cf on the b-pillar know how to remove it? I have some areas where the cf has seperated from the tape and have no way of fixing it.

 

Interesting. And odd. Certainly not our CF. That would never happen. But your B pillars pop off which makes it easier to work on them. Warm them in the sun and start pulling. Get an edge up and use a razor to slice or split the tape. You can roll off whats left with your thumb.

 

Don't mean to hijack your thread TN, sorry.

pinnacleliquid, I PM'ed you almost more than a week ago but got no response. Is there any way I can find out my shipping status on my red CF B-Pillars? When I ordered over the phone one of the employees there told me they would be on back order and they'd be shipped as soon as they arrive. Just wanted to know if they are in stock, thanks.

 

Disregard above message, thanks!

 

takin off the whole B pillar would take too long. I think you be able to get it off with a heat gun or hair dryer. Heat up the CF evenly and then pull it off. If your still having trouble get some fishing line or dental floss and use it to slice the tape in-between.

Good luck!

 

I have the same problem and man that 3M adhesive is strong. anyway igave up and ordered new b pillars from nissan 90 bucks
and i talked to elegent dood designs about coating the factory b pillars like they do on their dash kits. they said this could be done ill be sending in the b pillers tuesday i think this will look pretty sweet as the stick on carbon fiber B pillar covers never looked that good as they dont lay completly flat and when the light reflects of of them they look wavy.

 

no it doesnt they pop in and out with ease it takes like 2 seconds.