sorry for the poor quality of the camera built into my cell phone, it was easy to use & readily available.....you guys get the idea anyways....heres the same pic as above w/o the glare:

 

I aint got mine yet ya'll are lucky. They got to ya'll house fast.

 

got mine yesterday =) in jerz

 

aint got mine yet either.

 

I'm sure everyone will have thiers soon.....well worth the wait!!

-justin

 

i agree well worth the wait...

 

i got some alcohol wipes & some primer sticks with my c/f pieces. now im sure the area where were applying the c/f pieces gets wiped down but do i need this primer stuff? i didnt get any instructions with mine so i want to be sure on the application.....

thanx,
-justin

 

Things few people know. The 3M tape bonds in a mechanical way. The acrylic will not gain adhesion upone initial tack at temps BELOW 65 deg F. It may seem to stick, but will fall off somewhere down the road. Laymens terms, make sure the parts that are going to mate are warm and about the same temp. Getting the CF warmed to about 85 deg F will help it conform and stick to curves. Dry fit the pieces to memorize moves so it all mates up nicely. The alcohol pads are to remove dirt and silicones. The adhesion promoter MAY be used. If applied, make the contact within 20 minutes but after 5 minutes.

 

thanx pinnacleliquid! looking forward to getting them put on.....

-justin

 

I just put mine on in the Cold the other day it seems to stick fine.. Should I run a heat gun on it to make sure? I really would hate for these things to fly off.

 

got mine the other day as wel, but i didn't get home to find that out untill today. Thanks guys They look great.

 

it may seem to stick, but is not fully set. unless warmed for a couple of hours, they will fall off.

 

This could be a stupid question, but gotta ask...i was looing at the bpillars the other day and im pretty sure not not positive...do the covers go directly over the existing one, correct?? Nothing has to be removed before i put these on....i didnt wanna go sticking these on and not have them on right. Thanx

 

they just stick on the existing. That is my understanding.

 

That is correct, just stick on the existing pillars, just as you do for the mirrors.....

Justin

 

thanx guys

 

i snapped a few shots of the c/f pieces installed on my z if anyone is interested in seeing them. i took some close-ups since im using my cell ph camera wich isnt that great. distance shots loose quality & dont even show the c/f........

-justin

 

another (brighter shot)

 

mirror 1

 

mirror 2