ATI Procharger cog belts
Thread Starter
Registered User
Joined: Jun 2002
Posts: 63
Likes: 0
From: Santo Domingo, D.R.
ATI Procharger cog belts
I want to order some replacement cogbelts that the ATI procharger uses.
Gates Micro-V k060615
Gates Power Grip GT2 Cog belt 560-8MGT-30 and 880-8MGT-30
Anyone know where I can purchase these online?
Gates Micro-V k060615
Gates Power Grip GT2 Cog belt 560-8MGT-30 and 880-8MGT-30
Anyone know where I can purchase these online?
Registered User
Joined: Apr 2003
Posts: 76
Likes: 0
From: Everywhere
Just FYI
I don't think $95 sounds that bad. I run a 8mm cog on my personal car. And the Belt FROM gates Direct is 150ish if I use Rubber, and over 200 if I run kevlar. Though you should not be suffering belt failure unless you have something out of alignment, or tension wasn't correct.
EA
I don't think $95 sounds that bad. I run a 8mm cog on my personal car. And the Belt FROM gates Direct is 150ish if I use Rubber, and over 200 if I run kevlar. Though you should not be suffering belt failure unless you have something out of alignment, or tension wasn't correct.
EA
Registered User
Joined: Dec 2002
Posts: 474
Likes: 0
From: Arlington Texas
I had to replace my Gates Power Grip GT2 Cog belt 560-8MGT-30 or should I say Grubbs Infiniti had too. When I had it dyno turned LoneStar Performance told me that they could get me extras for $30 each. You might want to give them a call and see how much they can get them for.
Thread
Thread Starter
Forum
Replies
Last Post
