I built these for my road race car but ended up selling it before I did anything with it. This is the Jenvey ITB Kit with custom forced induction plenums and I'll also include the Jenvey NA horns depending on if you are in between builds. Also included is a stock accelerator pedal, throttle cable wire, etc.

Included:

(6) Jenvey ITB Throttle Bodies
(2) Custom FI Plenums
(2) Jenvey Fuel Rails
(1) Nissan Accelerator Pedal modified for throttle cable
(1) Jenvey TPS
(1) Air Meter
(1) Crossover Tube with Wiggins Clamps

I also have a set of Siemens 2200cc Injectors with only a few hours on them that I will sell for an additional cost. If you are going to run the forced induction plenums you will need to make piping to an intercooler. Any questions please ask.

Priced at $2,995 (Jenvey kit alone is over $2,000)

 

what would be needed to run this in N/A form for an HR motor? I currently have the cobb access port...thanks

 

HR or DE engine?

 

Pretty sure that is for HR.

 

thats pretty sweet. Assume the rail height was built around standard OEM sized injectors?

How far does the plenum hang over the valve covers? any pics on a motor?

 

too bad its not for de

 

If it was DE I would be all over this

I was waiting for one of these miracles to pop up in the classifieds

 

These are for the DE. I just designed it for a twin plenum, dual inlet intercooler setup.

Before the BOV's were relocated due to firewall clearance issue.

 

It is definitely for a DE. Been eying a set for my BSP car, but probably going to hold off for now...

 

WOW that is sick! GLWS!

 

The itb can fit on an hr motor minus the air horns i am assuming?

 

I don't know the distance between inlets on the cylinder heads and do not have any to measure.

Greg

 

way too much fab work would be needed to mate this to a vortech, huh?

that is beautiful work.

 

can uprev make this thing work?

 

That's just a work of art.. Lovely

 

VERY nice!

 

Thank you. If anyone is just interested in going NA (kit without the manifolds), I will sell the kit for $2,300 as I might have someone interested in the manifolds.

 

Just to clarify, the NA kit would include all the horns, linkages, pedal and rails? Everything besides the crossover tube and plenums?

 

Will this fit a revup and stock hood without problem?

 

Those don't look like the horns made to fit the 350Z hoodline but I may be wrong. They look like the non-350z VQ kit. This kit will otherwise fit a Revup.