how to apply rtv gasket on kinetix plenum
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: Jun 2003
Location: so cal (mpk) - tokyo - taiwan
Posts: 672
Likes: 0
Received 0 Likes
on
0 Posts
how to apply rtv gasket on kinetix plenum
hey guys, the cork gasket on my v4 plenum has cracked and fallen apart, and i have to remake the gasket with rtv silicon. question is, the type of gasket calls to apply the gasket and install the part while its wet allowing it to squeeze out to form a complete seal. now...should i apply the gasket on the keintix plenum itself, or on the lower oem plenum? and what happens if the silicon squeeze onto the inside of the plenum? do i have to worry about bits and pieces going into the engine? thanks
#3
Retired Admin
iTrader: (95)
It doesn't matter which half (top or bottom) to put the sealant on; the sealant will adhere to both top and bottom anyway.
The excess silicone that oozes a bit into the plenum most likely won't harm anything as long as you give it time to dry and cure first. The plenum spacers have sealant oozing from them, too, if you look after a year or two of daily driving.
The excess silicone that oozes a bit into the plenum most likely won't harm anything as long as you give it time to dry and cure first. The plenum spacers have sealant oozing from them, too, if you look after a year or two of daily driving.
Thread
Thread Starter
Forum
Replies
Last Post
allmycarsdie
Engine & Drivetrain
15
05-13-2016 04:38 PM
Tochigi_236
Feedback & Suggestions for Our Forum
8
09-27-2015 03:40 PM