Borla Headers, RT Cats & Borla Dual Ex vids
Below are a few vids of my Z with borla headers, RT cats and Borla dual exhaust. These vids are with the stock intake and stock plenum (the Injen intake and crawford plenum are sitting in my garage until I get the ECU tuned) and my exhaust is normally a little deeper. Vid #1 was taken at night with my camera sitting on the ground so it's essentially audio only.
1.Start up
2.Start up inside
3.Idle
4.1st-3rd
5.1st-4th
1.Start up
2.Start up inside
3.Idle
4.1st-3rd
5.1st-4th
I could be wrong but your tach doesn't seem to match the revs from the sound of it (5th vid). Am I right? If so, did this happen right after your reclashed the ECU? (becasue that did happened to another Z buddy down here).
Last edited by frenzee; Jan 3, 2004 at 10:28 AM.
Originally posted by frenzee
I could be wrong but your tach doesn't seem to match the revs from the sound of it (5th vid). Am I right? If so, did this happen right after your reclashed the ECU? (becasue that did happened to another Z buddy down here).
I could be wrong but your tach doesn't seem to match the revs from the sound of it (5th vid). Am I right? If so, did this happen right after your reclashed the ECU? (becasue that did happened to another Z buddy down here).
Trending Topics
Originally posted by durobred
maybe my speakers are messed up....it sounds like a deep rumbling farting sound...
maybe my speakers are messed up....it sounds like a deep rumbling farting sound...
Originally posted by TheBigShow
u didn't say anything about how it feels; i think that's more important, man. how's it pull?
u didn't say anything about how it feels; i think that's more important, man. how's it pull?
.
Originally posted by PhoenixINX Baseline dynos vs. Dyno now?
.
Originally posted by durobred
maybe my speakers are messed up....it sounds like a deep rumbling farting sound...
maybe my speakers are messed up....it sounds like a deep rumbling farting sound...
Thread
Thread Starter
Forum
Replies
Last Post






