Clutch Not Disengaging
#1
Clutch Not Disengaging
Hello,
I'm having an issue where my car grinds every gear (except reverse I think) unless I rev match.
I'm guessing that the clutch is still engaged.
Pedal feels fine, clutch isn't slipping.
Pilot bearing has been making noise for a while now, but every older Z I run into has the same rattle.
Car is a 2003 with 65,000 miles.
Should I bleed the clutch? (heard that's a nightmare) Change the fluid? Adjust a cylinder?
Any input is very much appreciated.
Thanks guys
I'm having an issue where my car grinds every gear (except reverse I think) unless I rev match.
I'm guessing that the clutch is still engaged.
Pedal feels fine, clutch isn't slipping.
Pilot bearing has been making noise for a while now, but every older Z I run into has the same rattle.
Car is a 2003 with 65,000 miles.
Should I bleed the clutch? (heard that's a nightmare) Change the fluid? Adjust a cylinder?
Any input is very much appreciated.
Thanks guys
Last edited by paulmess7; 04-25-2012 at 08:19 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM