I just joined the SF-Winning Club :)
Thread Starter
Registered User
iTrader: (13)
Joined: May 2004
Posts: 6,002
Likes: 0
From: Ontario, Canada
Originally Posted by B-Unit
looks good but u need a drop!
Well, that pic the springs haven't really settled yet. plus i haven't gotten my alignment yet, so hopefully after I bring the camber back into spec the thing will look a little lower.
Originally Posted by noodleman
It's already dropped on RS*R's... Well, that pic the springs haven't really settled yet. plus i haven't gotten my alignment yet, so hopefully after I bring the camber back into spec the thing will look a little lower.
Well, that pic the springs haven't really settled yet. plus i haven't gotten my alignment yet, so hopefully after I bring the camber back into spec the thing will look a little lower.Have them slam it, then get ur alignment done.
RSR drops about the same as Hotchkis, I scrape bad enough as it is with the same drop. Sucks but I like to actually DRIVE my car.
If I didn't have VDC i'd do the "Bubble" trick and put a higher profile tire on the front...
If I didn't have VDC i'd do the "Bubble" trick and put a higher profile tire on the front...
Thread Starter
Registered User
iTrader: (13)
Joined: May 2004
Posts: 6,002
Likes: 0
From: Ontario, Canada
haha, yea, i would slam it if it would pass the gf test haha, plus i do daily drive this thing, and the canadian roads are in pretty bad shape...any lower and I think i'd have lots of problems.
As is right now, the gap isn't HUGE, which was what i went for, so i'm happy
Edit: oh yea, the other thing might be that this is the passenger side, and i've read that the passenger side is always higher than the driver side due to the weigh bias to the driver side. So this gap might look smaller on the driver side...i'll try to get a shot from the driver side and see if the gap is the same size.
As is right now, the gap isn't HUGE, which was what i went for, so i'm happy
Edit: oh yea, the other thing might be that this is the passenger side, and i've read that the passenger side is always higher than the driver side due to the weigh bias to the driver side. So this gap might look smaller on the driver side...i'll try to get a shot from the driver side and see if the gap is the same size.
Last edited by noodleman; Apr 10, 2006 at 10:36 AM.
Thread Starter
Registered User
iTrader: (13)
Joined: May 2004
Posts: 6,002
Likes: 0
From: Ontario, Canada
Originally Posted by GQ 350z
GF test? Tell her to STFU and go slam your ride.
1.2" drop, minimum! SF winnings for life here hahaah..
1.2" drop, minimum! SF winnings for life here hahaah..
and as i said, i'm happy with it, and that's all that really matters (i won't give into peer pressure, i won't give into peer pressure.....
)
Whatever makes you happy =)
Car looks good bro. I actually have the same springs, but i have the RSR down springs. I like the drop as it is. I like to drive my car as much as possible, any lower and these Ohio roads will eat my Z alive. Dnt listen to the suspension slammers lol cough cough Ravi 
Thread
Thread Starter
Forum
Replies
Last Post
Extreme Dimensions
Southern California
0
Sep 24, 2015 03:35 PM
Subarism
East Canada
0
Sep 23, 2015 06:23 PM