Not too bad, just start in a corner and work your way around. I **** deiseled one of the clip mounts off the rear center piece of the hatch, its was just like cardboard and I ripped it right off .

I would invest in two tools to make this easier. One is a little pry bar that fits our clip size and makes them pop right out and the other in a pair of reverse style pliers that removes the pop-up style clips in the wheel wells and bumper.

Oh, make sure to check one of the DIY threads to take the hatch pieces out in the right order or you will bust off clips.

 

WOW just got nightmares. That was a fun day.

 

Jose, I should have them installed by the skyline drive cruise, so I wouldn't mind letting you try it out then. Im gonna wait for it to get a little warmer before I put them on. And I still need to save up so I can get the camber and toe rods too, cuz Im not trying to run through what's left of my tires in like a month haha

 

I wanted to have my suspension in by then too...but it can wait. I'm in no hurry. I want to be sure I'm happy with the suspension I pick. I'm really leaning towards the Stance GR+ Pro's.

 

That's sick man. Yea I really think and hopppeee that Im gonna be happy with these.

 

So I got my cables run yesterday for the rear remotes. It was pretty easy actually, just had to remove some panels, and run the wires. It was nice on the passenger side actually...there are some little plastic wire holders already exisiting, it looked like they were there for a right hand drive vehicle, because there were identical ones on the drivers side, but they were already filled with the speaker wires, etc.. So I just ran the cables along where the speaker wires run, and up to the footwell, and mounted the brain near the side of the headunit under the console. Just got to run the front cables now, and somehow get them through the firewall, and also hook up the power supply cable.


Anyone know what it means when there is a 12V Power wire, and ALSO a 12V Accessory wire, as well as negative wire, and a wire for hooking up to the lights, so the display backlights when the car lights are turned on??? I understand where everything would go, except for the 12V accessory....?

 

my guess is it's an ignition wire? Kinda like amps have a remote wire, so that the amp only turns on when the ignition is on. Just a guess. I don't know.

 

you could use the 12 access wire of the cig. lighter

 

you suck paul!

 

I AGREE!

 

paul how much did you get everything for?

 

paul is lame he got them for a baller deal

 

hey paul i want to come see them in person. ill help with the install

 

Hahaha you can come help do the install, it should be a snap. Just got to bolt everything in basically, and make sure that the heights are the same from left to right.


Jonathan, I got everything for 1390 shipped to mah house. MSRP..... 2300 : )

 

nice

 

chea. Should be getting the coil springs powdercoated tomorrow...

 

where at

 

Glen Burnie, or Elkridge.

 

oh ok kool paul i texted you text back sir hahah

 

hAHAHA Dude im freaking stoked to put these beeeetches on. I want to so bad.