Hi. I have own 2007 350Z about two years now. Still completely stock. This summer, I would like to start get some bolt ons. I could do most of the work (experience wrx owner). But I rather have a experienced shop work on my Z for hella flush set-up. Originally, I thought Mach III will be perfect. I heard good things about them from I-club (bay area subaru community), but not so much here. Anyone care to comment.

Again, I would like to get a flush set up for the Z. Where would you take your Z for that. I'm located richmond/oakland area.

Thanks

 

nobody?

 

flush as in dumped so that the wheels are flush with fenders?

just buy the parts and get em installed...

whats your handle on iclub?

 

ok flush set up is
9.5 in front 10.5 in rear +22 offest << regular flush (with 275 in rear you don't need to roll fender if you put 285 thne you need to roll fender)

you can go as extreme as 10.5 +12 offset in front with little negative camber and rolled fender.

I hope this help.

Mach III is good shop but they a bit pricy if you wanna get good deal look for Vendor in forum.
I already told you the spec.

 

MACH 3 is pretty good. go look for Ray or Kris and tell them Jackie sent you. Kris is also on G35driver if you want to pm him.

 

well how flush you wanna go..
wanna go flush w/ roll of fender standard tire? 245/275 minimal camber
or are you going extreme w/ a roll stretching and thin tires and max camber?
it all depends..
also there is no right or wrong way.
I've worked at autornd before i left and we did a few z's.. its all on you.. this forum is a great place to ask around especially the wheel / tire section. Also look at toher people's setups. You don't necessarily need to go local you can always as other members have said go with other forum sponsors.

 

Im not trying to sound like a douche, but I dont really see why you would need to find a shop to do a flush set-up. What is your definition of Flush??

 

+1 for Kris79 on driver

 

If anything, you need to find an alignment shop that knows how to make the set-up look "flush," not a shop that just sells wheels. Ask Z Car Garage where they send their cars to get alignment done, I forget the name, but they'll know, and that shop will do the alignment however you like.

 

I went to Cort of Tyre Treads 510-581-3378 in Hayward. I bought all the parts (wheels, coilovers, camber kit) and he did the rest which included rear fender roll, alignment, install parts, etc. Funny thing is he, like alot of folks, dosen't really like this look...but did a killer job of getting it done for me.

Tell him Na'im (naw-eem) sent you...!!! Good Luck!!!

 

Thanks eveyone. I think I'm going to do some research and go with forum sponsors as mentioned. Perhaps I would just need a good allignment shop and someone who could roll fenders.
I'm going to go with regular flush rather than extreme.

 

I think I'm going to go for slightly a bit more flush. Anyway, that Z looks clean. I like it.