well [i dont think my car is low enough hopefully get a suspension next week

 

https://my350z.com/forum/showthread....ght=buddy+club
i'll lower it some more after i get a camber kit lol

 

 

Dropped mine 1.5 inches and no problems

 

Raise that bit&h up a few inches, that slammed look ain't working

 

 

offsetz33 your car is ******* hawt!

 

on stance, V1 front, only a cogarette pack can clear the front. thats all I know.

 

I have a Veilside V1 lip on Nismo suspension, my front clearance is roughly 4-4 1/2 inches. Its not terrible, but i have a tough time with most speedbumps or taller driveway inclines... i always have to take them at an extreme angle. It would look even better about a 1/2 inch front/rear lower, but would be a real hassle in certain places.

 

Stock bumper is 2 3/4 inches off the ground, and stock sides are 2 1/2 inches off the ground. DUMPED FTW!!

 

lol nice old thread bump! haha

STANCE SUS
F: tire tuck
R:tire tuck

 

the last pic is what happens when your too low

 

dropped on H&R Springs....

 

woooooooooooooooo bad a$$ in here

 

both Z's drop with tanabe gf 210

 

Stance FTW! This pic is after I raised it 3/4" rear, 1/2" front

 

Raised it??? What was the initial drop? I think I'll be getting the Stance Coilovers just from the reviews and how much It can be dropped. Any of you with the stance coilover track your car? Sorry not trying to thread jack...

 

I love this setup, what is the size/ offset of those. Yur car has got me thinking....

 

See thread in this forum "Enkei RPF1 10.5 all the way around". They look and feel so sick.


Advent7 - I bought the Stance with about 2K miles on them, so someone else had them set super low. When I first put them on I couldn't accelerate without my exhaust scaping! They go up to stock height too.

 

Stance also,