Messed up finish on stock wheels
Thread Starter
Registered User
iTrader: (1)
Joined: May 2007
Posts: 55
Likes: 0
From: Charleston, SC
While at the dealer this morning for a pesky electrical problem that was frying my radar detector, I was walking around the car and noticed what appeared to be brake dust on the wheels. Long story short it wasn't brake dust, as a matter of fact it looked like the finish on the wheels had worn through in spots. All four wheels had the same issue to varying degrees. Anyway mentioned it to the service guy, who called over the service manager, etc. and as it turns out the finish on the wheels was defective.
They asked a few of the standard questions like "What did you clean it with ?", "Did I run through any chemicals?" etc. and when I told them I had used the supplied cleaners exclusively on the car they shuffled around a bit but finally said they needed to be replaced. So.... they called parts and had them bring out four brand new wheels
They are being installed on the car as we speak! My cost..... $0.
Just thought I would share that with anyone who might be having a similar problem. I know I should have taken pics but didn't think about it until after I had left the dealer.
They asked a few of the standard questions like "What did you clean it with ?", "Did I run through any chemicals?" etc. and when I told them I had used the supplied cleaners exclusively on the car they shuffled around a bit but finally said they needed to be replaced. So.... they called parts and had them bring out four brand new wheels
They are being installed on the car as we speak! My cost..... $0.Just thought I would share that with anyone who might be having a similar problem. I know I should have taken pics but didn't think about it until after I had left the dealer.
Thread
Thread Starter
Forum
Replies
Last Post
Dark Knight
Wheels Tires
7
Nov 11, 2015 08:40 PM
CFAUVEL
Exterior & Interior
3
Oct 1, 2015 03:20 PM





