When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Newest photos of my ZR with 15mm spacers, Red brakes, fender work and finally went lower. Pics are from the CT Nissan Club meet at RDZ in Danbury CT courtesy of drop bomb clothing.
Last edited by nismo4life11; Jun 12, 2012 at 02:18 AM.
how did u do that process?
just pull or something else
we used a fender roller to catch the edge of the fender and bend it upwards while hitting downwards with your hand. only reason i was able to do this was because i shaved my fenders and cut the inner fender liner out so i have a small thin layer that was easy to bend.
Originally Posted by Jose2008Z
Why oh why do people do stuff like this??? Why not do it properly with bodywork? You dont drive a civic!
Originally Posted by GenX350z
i agree with you on that! why sacrifice a good fender just go an "inch" lower??? couldve used a fender roller and a 30mm spacer to get a nice pull. i wouldnt mess up my fenders like that just for a inch lower.. just sayin. not hatin, just agreeing.
my fenders were already ****ed from shaving them so i was unable to roll since it just split when i tried. i plan on getting real fender work in a few months however this was to hold me over till then so relax, it will all work out in the end
trying to fit a 12 on a stock fender didnt work to well as i barely tucked tire and looked like a monster truck in the rear
Anyone have the link/diy or pictures of cutting out the inner fenerwell/strut tower for uca clearence?? Ive seen it many times, but now cant seem to find it anymore
You dont drive a civic! 
