Any1 here has a picture of 18" TE37 on a Z? Please help me out.

I might going to order one set of them soon. I need to compare them with the face of 19"TE37. I'll probably go for bronze 18x8.9F&9.5R +22 on my PPW, since a silver would take 3 months =( Yes i'm going to lower my car asap, probably with RS-R down spring, heard many good comments about them on this board.

Any bad comments on this setting? I'd appriciate
Thx

 

the 19s would look much better, i was wondering the same thing before i got my TE's.
but i went with 18's for the performance and weight advantage.

 

I kno the 19" looks better since it has a different face that's designed for Z.
However, just like you said, i dont want to loose any of the z's performance!!! therefore, i probably will pick 18" TE37. I think the bronze TE37 would look good on 18" since it enhance the performance image.

Anyone else? no pics?

 

ares, forum moderator and inventor, has 18" bronze TE37 on his black Z. Ask him.

 

OK I'll bite.. Here are some pics of my 18" te-37's.. 8.5 wide in front, 9.5 in back, +35 offset, merc silver.. Toyo T1-S, car lowered about ~1" all around with Tein Basic coilovers.









--mike

 

I think these are 18s.

 

http://www.350zonline.com/gallery/al...IC_Drift_Car_1

hows this one?

 

nice pics... i think you'll be OK with the 18s since you're lowering... personally i like the face of the 19s better though (has a concave look)

 

You can get the 18's with a "concave look" too.. I think the JIC drift car is running 18's with a +22 offset.. which gives you that concave look.

--mike

 

Oh, I thought you had to go 19 to get the concave look.

 

Jic's race car i think they run 9.5 +22 F 9.5 +12 R
becuz 8.5 +22 does not have the concavity

 

Why not the 18" Nismos? They are readily available in 18" size, have the concave look for the rears, have 5 spokes rather than 6, and I believe are cheaper. They are made by Rays, the same people who make the Volks. They are a great performing and a great looking wheel.

Lou

 

Sorry

 

Another